Length of the Outer Tube on etrailer.com Landing Gear Set # RVLG-8000

Question

Question:

Will this fit on a Salem 2010 by Forest River its a r25 fifth wheel I need to know the total length of the two and a half inch tubing from top to bottom

asked by: Luke W

0

Expert Reply:

The Landing Gear Set - 20-1/2" Travel - 8,000 lbs # RVLG-8000 will fit your 2010 Forest River Salem 5th wheel. The length of the 2-1/2 inch square tubing you requested is 29-3/8 inches. I've attached a photo to further assist.

expert reply by: Jason S

0

click to enlarge

Answer 1

For your VMC900R landing gear if you want to replace the lead leg I recommend the Replacement Lead Leg for Stromberg Carlson Landing Gear - 33-1/2" #LG-177202 and then for the follow leg #LG-177201. I've attached a photo of the measurements…

view full answer...

Answer 2

To replace your existing Venture motor, the Lippert Components Venture 5th Wheel RV Landing Gear Motor #LC142178 is the correct replacement part for you. For an aluminum gear box, you are correct that you can use part #LG-179015. The #LC142178 motor…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Good news! I was able to go out to the warehouse and measure the etrailer landing gear #RVLG-8HDL for you. I found that the distance between the weld stops from the outside to outside is 17-1/2 inches and from the inside to the inside of the weld…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

I don't have any way of determining if the Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear #RVLG-HDL will work with your 2007 Fleetwood Nitrous Hyperlite TT Toy Hauler or not, unfortunately. The Replacement Crank Handle…

view full answer...

Answer 7

To determine the best landing gear option for your 1997 Forest River Sierra you'll need to measure the where your weld-stops sit to see if there is a matching set so that you can swap over without having to cut off the old mounting brackets and…

view full answer...

Answer 8

There are a few things that go into making sure you choose the correct replacement landing gear. First you need to be sure that the landing gear is rated properly. If you check out the weight rating on your current landing gear just make sure the…

view full answer...

Answer 9

The sure way to pick out replacement landing gear for a trailer that will bolt right up to the current brackets is to measure the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) if it…

view full answer...

Answer 10

The gearbox #RVLG-RDBOX for the Landing Gear Set w/ Handle #RVLG-8HDL can be mounted in the horizontal or vertical position. I went out to the warehouse and tested both the gearbox and lead leg together and the pins that hold the gearbox in place…

view full answer...

Length of the Outer Tube on etrailer.com Landing Gear Set # RVLG-8000

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching