Replacement Yakima 1A Raingutter Spacer Brackets

Question

Question:

Hello just need the spacer. Do you guys sell just the spacers for the 1A? Tim

asked by: Timothy B

0

Expert Reply:

To replace the spacer, you'll need to purchase the full hardware kit, part # Y8810136 . The spacers are not available as a single part.

expert reply by: Jacob W

0

click to enlarge

Answer 1

Hey Ben, I attached a picture that shows how to use the spacers of the Replacement Hardware Bag for Yakima 1A Raingutter Towers #Y8810136.

view full answer...

Answer 2

It sounds like you are talking about the shear block bases #Y8810007 for the Raingutter towers such as #Y8810137. This is a set of 4. Other replacement parts for the Yakima Raingutter 1A towers include: Boot set #Y8810008 Another shear block set…

view full answer...

Answer 3

I checked with Yakima just now and they state that the #Y8810136 fits the 1A towers that were made all the way back to 1980 so they would fit yours that were made around 1990.

view full answer...

Answer 4

Yakima refers to the part you're needing as a clip spacer for their 1A RainGutter Towers, part #Y00101. The replacement plastic clip spacers aren't available individually, they are included in the #Y8810136 replacement hardware bag, so…

view full answer...

Answer 5

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 6

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 7

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 10

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 11

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 12

Tracks can absolutely be installed on the roof of your A.R.E. Truck Cap to provide a mounting system for a roof rack. For this I recommend the Yakima Tracks, which come in 42 inch #Y01126, 54 inch #Y01127, and 60 inch #Y01135 lengths. These tracks…

view full answer...

Replacement Yakima 1A Raingutter Spacer Brackets

Product Page this Question was Asked From

Continue Researching