Replacement 7-Way Trailer Wiring Connector for 2004 Dodge Dakota

Question

Question:

I need to know the color code for the wires

asked by: Lawrence O

0

Expert Reply:

To replace a 7-way on your 2004 Dodge Dakota all you'd need is the part # HM42190 which will plug right into the square connector on your truck and would not require you to do any splicing.

expert reply by: Jameson C

0

Answer 1

There are a few troubleshooting steps to help you figure out why you have no power. I would start by making sure that there is not any corrosion or debris blocking your connection points. If they are clean or still no power after cleaning, I would…

view full answer...

Answer 2

The Hopkins Endurance Quick-Install 7-Way Trailer Connector, part #HM42190 is compatible with your Rubicon if it has a factory tow package and a 7-way trailer connector at the rear of the vehicle. Since you said you have a 4-way connector at the back…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

As far as wiring for the 2024 Toyota Grand Highlander, we do have the Curt #C59236 available which is more of a universal hardwire harness. Unfortunately there are not any plug-and-play options that have been confirmed to fit as of yet (October 4,…

view full answer...

Answer 11

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 12

It is very easy, as you just use the included clamps to secure the Caprock to your roof rack crossbars. The clamps are secured to the channels under the platform, and can be positioned wherever needed to accommodate the spacing of your crossbars. And…

view full answer...