Recommended Skid Wheels for 32 Foot Class C Motorhome

Question

Question:

I have a 32foot Class C motorhome and need skid wheels that will fit on my 4inch bumper rather than welded to the frame. What should I purchase?

asked by: Hogo

1

Helpful Expert Reply:

For your 4 inch bumper on your Class C motorhome, I recommend using the Ultra-Fab Skid Wheels for Class C RVs up to 34' Long - 5" Diameter - Qty 2 # UF48-979012. As long as your 4 inch bumper is welded to your frame, you can bolt these wheels to the bumper and be good to go as long as you don't have anything that hangs below your bumper.

expert reply by: Jason S

1

Answer 1

Here are the instructions for Swivel Skid Wheels #UF48-979012 1. Position a board as shown in Illustration 1. Place one end of board just behind rear wheels. Prop up the other end of board so board comes in contact with the lowest point of RV’s rear…

view full answer...

Answer 2

Yes, the Ultimate Trailer Jack part #322-RDJ-2K is the perfect option to prevent bottoming out the tongue jack since you can adjust the shaft on the base to ensure you have as much ground clearance as possible. It also makes lifting and lower the…

view full answer...

Answer 3

We don't offer airbags, like what is normally installed on a tow vehicle, for trailers. We do have jounce-style helper springs that may work for you. The Timbren Trailer Suspension Enhancement System #TTRA1702 install onto your trailer's…

view full answer...

Answer 4

For your 32' 2020 Pioneer BH270, I recommend the Ultra-Fab Skid Wheels #UF48-979012. These are 5" diameter urethane wheels for RVs up to 34' long. This includes two casters and two mounting brackets that weld onto your trailer RV frame…

view full answer...

Answer 5

Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball mount…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

The best skid wheels for your 31 foot Forest River Forester are going to be the Ultra-Fab Skid Wheels #UF48-979012. The 5" diameter wheels are bolted to brackets which are welded onto your RV's frame. Please keep in mind skid wheels are only…

view full answer...

Answer 8

Here are the instructions for Swivel Skid Wheels #UF48-979012 1. Position a board as shown in Illustration 1. Place one end of board just behind rear wheels. Prop up the other end of board so board comes in contact with the lowest point of RV’s rear…

view full answer...

Answer 9

You can install the Ultra-Fab Skid Wheels for Class C RVs, #UF48-979012 the way you describe but yes that would change the stress as you identified. If too much or not, depends on the abuse you apply. These are intended to accept the abuse that would…

view full answer...

Answer 10

The length of your Jayco Greyhawk 30Z is 32-1/2 feet which means the skid wheel part #UF48-979012 would be the correct kit as it's designed for RVs up to 34 feet in length.

view full answer...

Answer 11

Skid wheels, including the Ultra-Fab Skid Wheels for Class C RVs up to 34' Long #UF48-979012 are not designed as fully weight-bearing entities so they do not have an official weight capacity. They are only meant as a stopgap for occasional use to…

view full answer...

Answer 12

You do not have to remove the skid plate on your 2007 Toyota Tundra to install Curt front mount receiver #31198 but you can if you wanted to. You should be able to loosen the skid plate enough to move the skid plate out of the way enough without…

view full answer...

Recommended Skid Wheels for 32 Foot Class C Motorhome

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching