How Does Buckle and Strap Conversion Kit # PARTS-356A0009 Install

Question

Question:

Do you have any instructions for where to install these? My Bakflip F1 on a 2015 Colorado doesnt seem to fit if I just returned the d rings that are the now. Thanks.

asked by: Timothy H

0

Expert Reply:

If you check out the picture I attached for the part # PARTS-356A0009 you'll see how it installs.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The straps measure 8-3/4" long in the Buckle and Strap Conversion Kit for BAKFlip Truck Bed Tonneau Covers #PARTS-356A0009.

view full answer...

Answer 2

I'm sorry to hear about your trouble. We have a tech who has made that same mistake. The problem he cited was the anchor on the other side of the screw spinning when trying to unscrew the strap, preventing the screws from loosening. If this is in…

view full answer...

Answer 3

Yes the buckle portion of the #PARTS-546A0002 is the same as what fits the Bakflip X4 which we have the replacement for that with the part #PARTS-356A0009.

view full answer...

Answer 4

I reached out to my tech contact at Bak Industries and there is not a conversion available for any of their products. They said that it isn't as easy as just trading out a panel for a shorter size. If you want the same model that is a confirmed…

view full answer...

Answer 5

That hitch does stick out pretty far on your 2021 Nissan Rogue! I can certainly understand wanting something a bit more recessed. We have the Curt hitch #C24HR which is much more recessed like you can see in the picture I attached. I could be wrong…

view full answer...

Answer 6

The Replacement Tie-Down for Extang Solid Fold 2.0 Hard Tonneau Covers - Qty 1 #EX1024 that you were looking at measures 1-3/4" between bolt holes on the strap's tie-down and measures 1-1/4" between bolt holes on the clip. I attached…

view full answer...

Answer 7

The distance between the mounting holes of the Extang buckle part #EX54560402 that you referenced is 1-1/4 inches.

view full answer...

Answer 8

The correct hinge seal for an Extang Solid Fold tonneau cover is the part #EX32560669. This is 69 inches long and would need to be trimmed down to the length you need.

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

How Does Buckle and Strap Conversion Kit # PARTS-356A0009 Install

Product Page this Question was Asked From

Continue Researching