Will Weight Distribution Be Needed on a 2017 Ford F-250 Super Duty

Question

Question:

We have a F 250 super duty four wheel drive with tow package we were using the Weight Distribution Hitch to pull the camper Forest River Salem Hemisphere Spec 272RL TBD Hitch Weight 845 lbs. UVW 7294 lbs. CCC 2351 lbs. Length 34foot 4inch Height 11foot 0inch Width 96 Question would the 2.5 inch be adequate for towing with the super duty and not use the weight distribution Can not seem to get a straight answer from any one

asked by: Gary M

0

Expert Reply:

With the trailer weight that you provided, I recommend using a weight distribution system with sway control on your towing setup. Any time the trailer weighs more than half of the weight of the two vehicle we recommend using a weight distribution system. Even using a hitch with a 2-1/2 receiver opening will not negate the use of weight distribution with a trailer weighing as much as yours.

I have attached a FAQ article on weight distribution that will have more information on when weight distribution will be needed on a trailer and tow vehicle combination.

The best way to pick out a weight distribution system is to base it off of the loaded total tongue weight of the setup. You should note that the weight of any cargo behind the rear axle of your vehicle should be considered tongue weight as well. I attached an FAQ on determining tongue weight for you to check out. I recommend using the etrailer Trailer Tongue Weight Scale, e99044, when trying to find your towing rig total tongue weight.

If you find out that your current weight distribution system needs to be upgraded due to the amount of your total tongue weight, then contacts us back and we will be happy to help you find a system to fit your towing needs.

expert reply by: Jared P

0

Answer 1

The 1988 Layton travel trailer nearest the 17-foot size you mentioned is their 16-foot model M-1661. The adhesive included in the etrailer kit #344270KITW is not suitable for use on the rubber roof on your trailer. However we do offer part #0160297,…

view full answer...

Answer 2

You can use the #AL74000 to add the air to your air bags before or after the trailer is loaded or the payload is added to the truck bed. Either way works and there aren't detrimental effects if you use one way over the other; it might be easier…

view full answer...

Answer 3

All 2017 F-Super Duty vehicles equipped with a factory trailer brake controller (TBC) utilize a trailer module (TRM) which initiates the trailer charging system. For trailer charging to operate, the TRM must detect a trailer is connected and a brake…

view full answer...

Answer 4

Since you are not getting the 12V power when your truck is running, you most likely don't have a fuse issue as you stated their isn't a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the…

view full answer...

Answer 5

The 12 volt power circuit of the 7-ways on the newer Ford trucks like your 2017 Ford F-250 is an odd situation. Many people have the same issue as you or they have found that the gauge wire used for this circuit is just too small to power anything.…

view full answer...

Answer 6

If you have already added the fuse and the trailer charge circuit is not activated in the 2019 Ford F-350 Super Duty with factory integrated brake controller, then you want to make sure the trailer is connected and you press the brake according to a…

view full answer...

Answer 7

If your 2016 F-250 has the "smart" tow connector, the 12 volt power circuit on the 7-way has to have the key on to activate. Because of the "smart" tow setup, you have to connect to a trailer and do a setup on the info setup that…

view full answer...

Answer 8

We had a customer who was able to replace his Dexter 8-155 hubs with the #8-201-5UC3-EZ that you referenced so they should work well for you. You can verify that this hub will work for you by pulling your current hub and making sure they have inner…

view full answer...

Answer 9

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 10

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 11

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...