Is a 4 Pole to 7 Pole Adapter Available for a 2013 Ford F-150?

Question

Question:

I have watched your videos but when I look in my truck I do not have the extra wires where the 7 way plugs into. My truck only has 4 wires going into the 4 pole. Is there a way to convert it? If it is not as simple as your video shows and I need to run cables where does the blue or brake cable plug into? Thank you

asked by: Eduardo S

0

Expert Reply:

If you are looking to install a brake controller on your 2013 Ford F-150, and it has the factory 4-flat, you would use the Hopkins Adapter # 37185 to convert the 4-pole on your truck.

Should you be missing the wiring completely, you would need universal installation kit # ETBC7.

expert reply by: Kyle S

0

click to enlarge

Answer 1

You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the…

view full answer...

Answer 2

Yes, you can power your enclosed trailer's interior lights with a dedicated trailer-mounted battery. For such an application high-efficiency LED-type lighting is ideal since these will draw only a small fraction of the power required by…

view full answer...

Answer 3

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

view full answer...

Answer 4

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 5

The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…

view full answer...

Answer 8

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 9

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

We have a online diagram that will help you understand how the break away system is wired into your trailer. It is actually a simple installation. The system splices into the existing trailer wiring. The break away box will have 3 wires coming out of…

view full answer...