Recommended Bayonet Flange For Waste Valve

Question

Question:

I need the Bayonet flange for the Valerra Twist on Waste Valve, like is on your Item #T58. Thank you

asked by: Ben H

0

Expert Reply:

For the bayonet fitting on your valve, you can use the Valterra Rotating Adapter for Rigid RV Sewer Pipe - 3" Hub to 3" Bayonet - Black Plastic # T1028, the Valterra Adapter for RV Sewer Hose - 3" Bayonet Fitting - Straight - Black # T1024VP, or the Valterra Hose Adapter w/ 3" Swivel Bayonet Fitting - Black # T1024-2VP.

For the other side of that bayonet, you may be interested in the Valterra RV Sewer Lug Fitting with Flange - 3" # T1009, the Valterra RV Sewer Termination Adapter - 3" Lug Fitting to 3" Hub # T1029-2 or the Valterra RV Sewer Elbow - 90-Degree - 3" Lug x 3" Rotating Flange # T1035 will give you the tube for the bayonet to connect to.

You can use the Valterra ABS Solvent Cement - 1/4 Pint # A05-0303 for any permanent fittings.

expert reply by: Jason S

0

Answer 1

We do have what you are looking for as the part #T1009. This will replace the flange side of your waste valve that you sent in a picture of and give you bayonet fittings you can attach to your sewer lines. It's hard to say but it looks like yours…

view full answer...

Answer 2

You'll first want to attach the LaSalle Bristol Clean Out Adapter for RV Sewer System #344633703 to your current setup and then you can attach either the Valterra RV Sewer Termination Adapter #T1029-2 or the Valterra Rotating Adapter for Rigid RV…

view full answer...

Answer 3

When gluing together Valterra RV sewer pipes like the #T1028 you'd need to use an ABS solvent cement like the part #A05-0303.

view full answer...

Answer 4

There is Schedule 20 and 40 sewer pipe that has an outer diameter of 3-1/2 inches like what the Valterra Rotating Adapter for Rigid RV Sewer Pipe #T1028 is designed to work with so yes it would fit if the size was correct.

view full answer...

Answer 5

Your fresh water hose is an easy recommendation, I suggest the Camco RV drinking water hose, 5/8" diameter at 75' Long, #CAM22803. This is a reinforced PVC hose for drinking water made of FDA-approved materials and BPA-free. Because you…

view full answer...

Answer 6

The Pure Power Blue Treatment for RV Holding Tanks, #V23128, is a chemical-free, biodegradable treatment that prevents odors and clogs by breaking down waste in your RV's waste tanks. Add at an equivalent of one ounces per 20-gallons of holding…

view full answer...

Answer 7

The Valterra Rotating Adapter for Rigid RV Sewer Pipe part #T1028 is designed to be welded to the end of a 3" ABS sewer pipe. However, if you don't want to permanently attach the sewer pipe to the hub fitting you could most likely just use a…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

For your 2018 Ram 2500 with the factory puck system the best 5th Wheel Hitch is the B&W OEM Companion. If you have the 8 foot bed then you will want the fixed 25K #BWRVK3600 and if you have the short 6-1/2 foot bed you will need the 20K Slider…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...