Measurements of Epicord 30 Amp Twist Lock Power Inlet - Black Item # 277-000138

Question

Question:

hi, need to know the exact size of that part. thank you and always appreciate your cooperation.

asked by: Guy M

1

Helpful Expert Reply:

I went out to the warehouse and measured Epicord 30 Amp Twist Lock Power Inlet - Black Item # 277-000138 for you. The overall width is 3-1/4 inches. the overall height (lid closed) is 4 inches or 7-1/2 inches with the lid opened straight up. The overall depth is 3-3/16 inches. I have included pictures showing these and other measurements for you.

expert reply by: Michael H

1

click to enlarge

Answer 1

To install the Mighty Cord Replacement RV Power Inlet #A10-30INVP that you referenced requires you to install a 2-7/8 inch diameter hole. That would be the size hole saw you would need.

view full answer...

Answer 2

The Epicord 30 Amp Twist Lock Power Inlet #277-000138 has it's own waterproof cover. The Weatherproof Cover w/ Threaded Ring #A10-30CV is designed to fit a Twist Lock 30 amp connector like the part #A10-30FDT.

view full answer...

Answer 3

If you have a typical hole saw set, then you will want to use a 3" hole saw on the Epicord 30 Amp Twist Lock Power Inlet, #277-000138. The outer diameter of the socket that mounts in the RV wall is 2-7/8 inches. If you wanted to be very…

view full answer...

Answer 4

The Furrion Power Inlet #F30ITSSS that you referenced is designed to fit in a hole that is 2-1/2 inches in diameter.

view full answer...

Answer 5

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

view full answer...

Answer 6

In order to wire your cargo trailer for both 12 volt DC and 110 volt AC power you would need to install a AC/DC distribution panel and power converter which we currently do not offer. You would then wire the 12 volt power to the converter along with…

view full answer...

Answer 7

Aside from the six 15A or GFCI power receptacles (5 interior and 1 exterior) and the breakers/fuses, we have all the parts you need to complete your project. For the power inlet on the outside of your horse trailer you can use the Epicord 30 Amp…

view full answer...

Answer 8

Yes, the red wires of the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp #PD4135K are going to be labeled with a 3-digit code with 001 being the wire for your battery's positive post and 002…

view full answer...

Answer 9

The white wire on the back of the Progressive Dynamics 4100 Series RV Converter #PD4135K just needs to be ran to the negative terminal on the battery.

view full answer...

Answer 10

According to Progressive Dynamics, with the 35 amp Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4135K you will need 8 gauge wire. I have added a link to a video review for you to check out as well.

view full answer...

Answer 11

According to the instructions for the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4135K, the negative side of your battery will need to be connected to the backside of the converter. I have attached a…

view full answer...

Measurements of Epicord 30 Amp Twist Lock Power Inlet - Black Item # 277-000138

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching