Suspension Height on 5th Wheel Trailer with Adjustable Spring Hangers
Question:
My spring hangers have 2 holes and spring is currently in top hole. Can I move spring to lower hole thus raising trlr 2 inches for a more level ride? I have 5 1/4 inches clearance on truck bed rails now.
asked by: Darrell
Expert Reply:
Usually leaf spring hangers have one hole on each side to allow the shackle bolt to run through the eye in the spring and then be secured to the hanger, as on a part like # E4139. But if your hangers have multiple holes to allow a choice of trailer height you can certainly use the lower set of holes to lift the trailer relative to the axle.
If you refer to the linked diagram you'll see the recommended minimum clearances for 5th wheel towing. 5-1/4-inches of clearance at the bed rails is adequate, but more is certainly beneficial when driving on twisty/hilly roads that can have the truck and trailer at different angles.
For instances when the trailer spring hangers do not provide adjustment capability we offer axle over/under kits # K71-384-00 and # K71-385-00 to lift the trailer.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Product Page this Question was Asked From
Front/Center/Rear Hanger for Double-Eye Springs - 4-1/4" Tall - 9/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 9/16 Inch Diameter
- 4-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- Redline
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Roadmaster Comfort Ride Shock Absorbers for Tandem Axle Trailers - 5,200-lb to 7,000-lb Axle
- Shop: Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers - Tandem 7K Trailer Axles
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Shop: Road Armor Shock Absorbing Equalizer Kit - Tandem Axle - Qty 2
- Shop: 6-Leaf Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long
- Search Results: 7k axle
- Article: How (and Where) to Connect an RV Propane Grill
- Shop: Replacement Lippert Correct Track Weld-On Axle Hanger - Qty 1
- Q&A: How To Adjust the Legs On the Lippert Ground Control Leveling System Separately
- Shop: Trailer Hitch
- Shop: Phoenix USA QuickTrim Hub Cover for Trailer Wheels - 5 on 4-1/2 - ABS Plastic - Chrome - Qty 1
- Shop: Lippert Bolt-On Shock Kit w/ Heavy Duty Gas Shocks - 5,200-lb to 7,000-lb (3") Overslung Axle
- Search Results: shock kit
- Search Results: shock absorbers
- Search Results: generator sliding tray
- Q&A: Electric Brake Assembly Replacements for Rockwell American 4704-L and R Assemblies
- Search Results: 5650
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Search Results: keyless door locks
- Search Results: 5th wheel rv shocks
- Q&A: Distance Between Hangers with 26 Inch Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Shop: Fifth Wheel Hitch
- Shop: RV Covers
- Video: Redline Trailer Suspension - Leaf Spring Suspension - 28-9-1 Review
- Q&A: Replacement Air Conditioner Recommendation For A Dometic Duo Therm 59516.531
- Video: Best Rooftop RV Air Conditioner Options
- Q&A: Increasing 5th Wheel Ride Height by Installing Taller Equalizer
- Q&A: Redline Hangers for Raising the Height of 5th Wheel Camper
- Video: Review of Lippert Trailer Leaf Spring Suspension - Axle Mounting Hardware - LC52SV
on Trailer Suspension Parts
