Trailer Hitch Fits for 2005 Subaru Outback Wagon

Question

Question:

What span of model years of tow hitches will fit an 05 Subaru outback wagon?

asked by: Jon

0

Expert Reply:

The four hitches offered for the 2005 Subaru Outback Wagon are shown on the linked page. These different hitch classes fit the variants of the vehicle, such as the Sport edition. On each hitch's page we list the compatible vehicles that the hitch will fit. For example, Draw-Tite 2-inch Class III hitch # 75560 fits the following vehicles:

2008 - 2009 Subaru Legacy
2005 - 2007 Subaru Outback Sedan excluding Sport
2005 - 2009 Subaru Outback Wagon excluding Sport
2005 - 2007 Subaru Legacy Sedan
2005 - 2007 Subaru Legacy Wagon

if you have a used hitch to re-install on a vehicle you will need to use new hardware since hitch installation hardware cannot be used a second time. It can only be torqued down once. We offer hardware kit # RHK. Just enter the hitch brand and part number in the fields on that item's page.

expert reply by: Adam R

0

Ken

5/17/2020

Does this fix a 2008 Subaru Legacy Wagon? Thanks!

Reply

Chris R.

5/20/2020

Yes, the Draw-Tite Trailer Hitch # 75560 is a confirmed fit for your 2008 Subaru Legacy Wagon.

Reply

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 3

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 4

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 5

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

A cover being installed on your spare tire would not prevent the Swagman Bike Rack part #S80501 from installing. The rack would still fit and work well. You might still compare the dimensions in the picture I attached with you spare tire so that you…

view full answer...

Answer 9

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 10

Most critical to trailer tire performance and durability are 1) proper inflation 2) observance of the tire's rated load capacity and 3) observance of the tire's speed rating. If either of these factors is off the mark then the tire will tend…

view full answer...

Answer 11

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Trailer Hitch Fits for 2005 Subaru Outback Wagon

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching