Recommended Trailer Hitch for 2006 Honda CR-V to Tow Motorcycle Trailer
Question:
Hi, I have a Kendon motorcycle trailer that I am looking to tow with my 2006 FWD Honda CR-V. It say it recommends at least a class 2 hitch. I am looking at the Draw-Tite Class III Max Frame Hitch 75690 and the Curt Class III Hitch 13535. I want to know if you can recommend which hitch I should purchase for the trailer I provided... Will trailer height issue be an issue for either of these two hitches? For the Kendon motorcycle trailer, it says trailer height is 19-21, requires a 2inch ball, and coupler ball size: 2 Thanks
asked by: Kien
Expert Reply:
The Draw-Tite Max-Frame Trailer Hitch Receiver # 75690 referenced in your question is a great choice and is the hitch I recommend for your 2006 Honda CR-V. This is confirmed to fit your vehicle and will provide a 2 inch receiver opening with a 3,500 pound towing capacity. I do also recommend verifying the vehicle's towing capacity as listed in the owner's manual, as this will likely be the limiting factor.
Based on the 19-21 inch hitch height of the trailer, you may simply need to use a ball mount with a bit of a rise in order to tow the trailer level. When installing this trailer hitch on the 2005 CR-V, we measured a distance of 14-3/4 inches from the ground to the top of the hitch receiver. To determine the exact rise you will need, you will want to measure from the ground to the top of the receiver on your 2006 once installed, as well as from the ground to the bottom of the coupler on your trailer. You will then choose a ball mount with the necessary rise or drop to fill the difference between the two measurements.
Going with an adjustable ball mount like the Buyers Products # 3371802225 might be a good idea. This will provide a maximum rise or drop of 6 inches and includes the 2 inch hitch ball needed for the trailer's coupler. I have also included a link that will take you to our available selection of ball mounts for you to look through.
Then to install a 4-Pole Flat trailer connector on your CR-V needed to power the trailer's signal lights, I recommend the Tekonsha T-One Vehicle Wiring Harness # 118336. The T-One connector will plug directly into existing wiring behind the driver side trim panel. I have attached an installation video on your CR-V for you to check out.
I have also included a couple towing articles that you might find helpful.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Buyers Products Adjustable Tri-Ball Mount for 2" Hitches - 6" Drop/Rise - Solid Shank
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- 1-7/8 Inch Ball
- 2 Inch Ball
- 2-5/16 Inch Ball
- Three Balls
- Steel Ball
- Steel Shank - Gloss Black
- Drop - 6 Inch
- Rise - 6 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- Class IV
- Buyers Products
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Wiring
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: Trailer Wiring Harness Installation - 2006 Honda CR-V
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Suspension Enhancement
- Video: Best 2006 Honda CR-V Hitch Options
- Shop: Transmission Cooler
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Article: Best Bike Racks for Electric Bikes
- Search Results: 75690
- Video: Trailer Hitch Installation - 2005 Honda CR-V - Draw-Tite
- Video: Trailer Hitch Installation - 2004 Honda CR-V - Draw-Tite 75690
- Q&A: How to Carry a 325 Pound Motorcycle with a 2006 Honda CR-V
- Shop: Brake Controller
- Search Results: 6 pin round to 4 pin flat
- Shop: B&W Tow & Stow 2-Ball Mount - 2" Hitch - 5" Drop, 5-1/2" Rise - 7.5K - Black
- Shop: Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K
- Shop: Buyers Products Adjustable Tri-Ball Mount for 2" Hitches - 6" Drop/Rise - Solid Shank
- Shop: Roof Rack
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Floor Mats
- Video: Draw-Tite Hitch Anti-Rattle - Standard Anti-Rattle - 63080 Review
- Video: Best 2006 Honda CR-V Tow Bar Wiring Options
- Video: Trailer Hitch Installation - 2006 Honda CR-V - Curt
- Q&A: Maximum Towing Capacity of a 2005 Honda CR-V
- Search Results: honda crv hitch
- Article: How to Choose a Spare-Tire-Bike Rack
- Article: Tips on How To Tow a Trailer
on Trailer Hitch
