Troubleshooting Melted Wires On Breakaway Switch
Question:
I just purchased a 2017 Blue Ridge fifth wheel and when backing into a spot the emergency break away pin was pulled and I continued to back a short distance before I realized what had happened. When I went to replace the pin it would not go back in and the insulation was melted off of the wires on the emergency switch. I have had this happen on my other fifth wheels and simply replaced the pin and continued on down the road. I can replace the break away switch but I must have some other problem. Any suggestions? Thanks.
asked by: Johnny R
Helpful Expert Reply:
Typically, any melted wires are an indication of a short in the wiring. You will need to check the wiring of your breakaway system, and look specifically at the wiring that connects to the battery. Look for any signs of damage or pinched or cut wires and fix as needed.
You may find that the wiring between the battery and the switch shorted out on the frame of your trailer causing the problem.
Product Page this Question was Asked From
Hopkins Engager Push-To-Test Trailer Breakaway Kit w/ Built-In Charger - Side Load - 7" Wire
- Trailer Breakaway Kit
- Kit with Charger
- Side Load
- Single-axle
- Tandem-axle
- LED Tester
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Shop: Brake Controller
- Video: Hopkins Engager Push-To-Test Trailer Breakaway Kit Review
- Shop: Replacement Switch for Curt Soft Trac I and II Trailer Breakaway Kits
- Shop: Hopkins Engager Push-To-Test Trailer Breakaway Kit w/ Built-In Charger - Side Load - 7" Wire
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Is A Breakaway Switch An Open Or Closed Circuit?
- Video: Fastway Zip Trailer Breakaway Switch Installation
- Search Results: trailer brake switch
- Search Results: trailer brake controller
- Shop: Fastway Zip Trailer Breakaway Switch with Coiled Cable - 6' Long
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Melted Trailer Breakaway Wiring
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Search Results: brake controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Video: Choosing the Right Brake Controller
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Trailer Hitch
- Q&A: How Can I Be Sure My Curt Triflex Brake Controller Is Working Worrectly
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Redarc Tow-Pro Liberty Brake Controller Review RED24FR
- Search Results: redarc
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: RoadActive Suspension Heavy Duty Versus Standard Duty
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Search Results: etbc7
- Shop: Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
on Trailer Breakaway Kit
