Dimensions of Curt Support Strap with Cambuckle for Bike Racks and Cargo Carriers

Question

Question:

How wide is the strap? How long is the strap?

asked by: David P

0

Expert Reply:

The Curt Support Strap # 18050 is 61 inches at its longest and is 1 inch wide.

expert reply by: Charles S

0

Answer 1

For a locking hitch pin to use with the Curt Cargo Carrier part #C18152 I would recommend the part #63232. This will lock the carrier to your hitch as well as work as an anti-rattle device.

view full answer...

Answer 2

We have not had the complaints that you mentioned for the Draw-Tite Max-Frame, part #76025. Most of the reviews from our neighbors stated that it's a very sturdy hitch even a year later. Several people have used this for bike racks with great…

view full answer...

Answer 3

The up and down play that you are experiencing is due to the tolerances that different manufacturers must allow to be sure that all accessories will work in conjunction with each other. In this case the hitch and bike rack are compatible but there is…

view full answer...

Answer 4

The Curt Stabilizer strap part #18050 is designed for stabilizing bike racks like your Swagman Original. Most hitches don't require the strap but if you have a Curt hitch you most likely have to use this strap to be compliant with the hitch…

view full answer...

Answer 5

It looks like on a 2005 Chrysler PT Cruiser convertible, you will have to place the hook on the strap #18050 in the gap between the body of the car and top of the trunk. You may have to open the trunk to get the hook in place and then close the…

view full answer...

Answer 6

Actually Curt no longer requires the use of the stabilizer straps like the #18050 with non-supported loads like bike racks with their hitches so it's not something you'd have to worry about!

view full answer...

Answer 7

Curt recommends the stabilizer strap with non-supported loads like bike racks to help support the hitch when going over bumps to prevent some of the vertical shock from being transferred to the hitch. Curt does this as a precaution, it's not that…

view full answer...

Answer 8

Stabilizer straps are no longer required when using a Curt hitch like the #C13130; this was an older requirement for some Curt hitches when using a bike rack only, but they have since determined that it is not required or recommended any longer. You…

view full answer...

Answer 9

I apologize for the confusion. I checked with Curt and since the Curt Hitch part #C13200 that you referenced is rated for use with a weight distribution system it does not require the use of a stabilizer strap like part #18050. Curt recommends the…

view full answer...

Answer 10

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Dimensions of Curt Support Strap with Cambuckle for Bike Racks and Cargo Carriers

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching