Dimensions of Easy Grip Assist Handle PLR6624-A

Question

Question:

can you tell me the dimensions on PLR6624-A we are looking for one inch diameter grab handles. thx

asked by: Guy.casazza@aps.com

0

Expert Reply:

The overall length of the Polar Handle part # PLR6624-A is 27-15/16 inches. The diameter of the handle is 1 inch just like what you are wanting so this should work well for you.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I do have a dimensional drawing of the Easy Grip Assist Handle part #PLR6624-A and have attached that for you. If this drawing does not contain the measurement you need just let me know what that is and I would be happy to take it for you.

view full answer...

Answer 2

I can confirm for you that the 12 inch Easy Grip Assist Handles are 22 inches long total and have mounting holes that are 20-1/4 inches apart (the 12 inches is referring to the grab area of the handle). This handle is available in either aluminum or…

view full answer...

Answer 3

The white socket of the Plunger and Socket Door Holder part #DH604 that you referenced attaches with a bolt that runs through the center of it. I attached a picture that shows the hole down the center.

view full answer...

Answer 4

To match your 1" long plunger you'll want the Plunger and Nylon Socket Door Holder #DH604. Just like with your old door holder these will hold your trailer doors open with ease by mounting one part to the door and the other to the side of…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Dimensions of Easy Grip Assist Handle PLR6624-A

Product Page this Question was Asked From

Continue Researching