Replacement Ventline Roof Vent Ceiling Garnish

Question

Question:

replacing 5 RV roof vent garnishes. 2002 Shasta class C. Dimensions are 16x16 outside. About 13-1/8 to 13-1/4 inside. kind of warped from UV damage. 2-1/4 leg length I can cut down a longer leg length. color is a very light tan. not polar white. but I can paint if necessary. brand is Ventline, but they have now standardized on a smaller version.

asked by: DON N

0

Expert Reply:

I've linked all of the Ventline ceiling garnishes for roof vents that we carry on this page. They're all designed to fit 14-1/4 by 14-1/4 inch vents.

The closest we have to your dimensions is # VA0445-26. I went out to the warehouse to measure it and it is right on with your 16 inches square outside and roughly 13-1/4 inches square inside. However, the leg is only 2-1/8 inches.

The color is birch white which isn't really tan but I would call it more like off-white or eggshell.

expert reply by: Charles S

0

Answer 1

The Replacement Screen Frame with Screen, Rocker Switch, and Wire for Ventline Roof Vents part #BVC0573-31R is designed for V2094 (older style with 1-piece frame and push button switch), V2193, and V2394 models. The model will be on a sticker under…

view full answer...

Answer 2

Since you have a Ventline V2394 the correct screen/frame you'd need is the part #BVC0573-31R.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...