Size of Replacement Cap Screw 852-3136-001

Question

Question:

Could you tell me the size/dimensions of the cap screw needed for the Thule 2inch hitch adapter? Thanks.

asked by: Marjorie

0

Expert Reply:

The part # 852-3136-001 is a M8x30 flat head screw.

expert reply by: Jameson C

0

Answer 1

I recommend using the M6 Flat Cap Screw #853-5787-02 since that's what Thule has listed as the part needed on their site. The Replacement M5 x 15 mm Bolt #852-3136-001 you referenced is for some of the bike racks Thule makes but according to…

view full answer...

Answer 2

The screw associated with the discontinued 852-3134-001 you mentioned is the part #852-3136-001 which is a M8x30.

view full answer...

Answer 3

The Thule Apex XT 4 Bike Rack #TH9025XT uses the Thule One-Key System. On the end of the lock cylinder it will have the key code N followed by three numbers. If you can provide me with this I can determine if a replacement key is available.…

view full answer...

Answer 4

I checked with Thule and for your Apex bike rack TH9027 the correct replacement 2 inch hitch adapter is the part #TH8523185001.

view full answer...

Answer 5

I went through the instructions and replacement parts for a Thule 9025 Apex 4 bike rack, but I was unable to find a replacement nut or washer. However, I did find the bolts and wrenches that are direct replacements. The #852-311-5001 (M6-25mm…

view full answer...

Answer 6

The Replacement 2" Hitch Adapter for Thule Helium Aero 2- and 3-Bike Carriers, #TH8523185001 does not come with the screw as you mentioned. I reached out to my contact at Thule to make sure you get the right part and it is Replacement Cap…

view full answer...

Answer 7

The part number you gave me is Thule's part number for Replacement 2" Hitch Adapter #TH8523185001. This is a fit for Thule Apex, EasyFold, or Helium Bike Carriers; this is what you will need to attach the bike rack to a 2"…

view full answer...

Answer 8

For a Thule Helium bike rack the correct 2 inch hitch adapter is the part #TH8523185001.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Size of Replacement Cap Screw 852-3136-001

Product Page this Question was Asked From

Continue Researching