Lower Drop Weight Distribution Shank Recommendation for Reese Dual Cam Setup

Question

Question:

I just got my new Reese duel cam pro sway system...my old shank a husky 6 hole 7-1/2 will not lower the ball low enough ..its 2-1/2 to high what shank should I order...

asked by: Cecil

0

Expert Reply:

The Curt shank part # C17123 would be what you need. It works with the Dual Cam setup and it has 10 holes that can be used so it will give you the additional drop you need without sticking down too far.

expert reply by: Jameson C

0

Answer 1

You are on the right track and have everything thought out correctly. You want the trailer to sit as level as possible and to do this you have to measure from bottom of coupler when level to the ground and then measure from the top of the hitch tube…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 7

Hey William, the E6 error on a Furrion wall thermostat indicates an Open circuit Humidity Sensor issue. Most likely the sensor is bad and needs to be replaced as this is a pretty rare error code.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Lower Drop Weight Distribution Shank Recommendation for Reese Dual Cam Setup

Product Page this Question was Asked From

Continue Researching