Does Air Bag from kit part # F2220 Match the Bag from Kit # F2071

Question

Question:

Just wondering if the air bag kit from firestone 2220 would work for a 2002 ram 2500 4x4 with over load springs it says it will work for the 3500 just wondering what the difference was.

asked by: Mike T

0

Expert Reply:

The air bag from the # F2220 is the part # F6781. The correct Firestone kit for a 2002 Dodge Ram 2500 is the part # F2071 which also uses the # F6781 as a replacement bag.

expert reply by: Jameson C

0

Answer 1

I sent your question to Tuson about the Tuson RV and Trailer TPMS #335TPMS4WIVS and they sent me the following with the attached picture: Based on our test results in an open space environment (without considering the shielding effect of vehicle…

view full answer...

Answer 2

Yes, the Center Point part #LC1565391 can fit a tandem axle trailer with 10k axles as we have confirmed with Lippert that it can be used on a tandem axle trailer that weighs 21,000 lbs. An air compressor is not included with this kit so that would…

view full answer...

Answer 3

The upper brackets for Firestone air bags #F2220 bolt through the frame but the frame brackets for Curt gooseneck hitch #C60734 do not have holes in them to accommodate this so this particular set up will not work together. If you could tell me if…

view full answer...

Answer 4

The Firestone Vehicle Suspension, #F2220, that you have referenced would be a good choice if your 1998 Dodge Ram has Contact Overload Springs. This kit works on either 2 wheel drive or 4 wheel drive models that have contact overload springs. I have…

view full answer...

Answer 5

You need to use the included shackles of the Lippert Center Point System #LC1565391 that you referenced. I spoke with my contact at Lippert and they emailed me the following: They would need to use the supplied shackles that came with the center…

view full answer...

Answer 6

I do have an option for you, however we do not have a rear air bag system available that is compatible with an in-bed hitch like the B&W Turnoverball Gooseneck on your 2001 Ram 2500. The mounting brackets for all of the air bag systems will use…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Does Air Bag from kit part # F2220 Match the Bag from Kit # F2071

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching