Dirt Bike Carrier and Ramp Recommendation for 2014 Subaru Crosstrek

Question

Question:

I have a 295 pound dirt bike. I own a 2014 Subaru Crosstrek. Is there a motorcycle ramp hitch and receiver combo that could haul my dirt bike? Thanks.

asked by: Andy P

0

Expert Reply:

There are a couple of ways to carry your 295 lb dirt bike with your 2014 Subaru Crosstrek.

A hitch carrier like the Ultra-Fab Motorcycle Carrier, part # UF48-979033 will physically fit in a trailer hitch for your vehicle. However, I took a look at the owner's manual for your Crosstrek and found that the tongue weight capacity of your vehicle is 200 lbs, so I cannot recommend going this route as this would exceed your vehicle's limitations. The tongue weight is the weight that is pushing down on your trailer hitch and the rear of your vehicle.

The safest way to carry your dirt bike with your Crosstrek is to tow a trailer. Your vehicle's towing capacity is 1,500 lbs. You will need a few things in order to do this.

First, if you do not already have a trailer hitch installed on your Crosstrek, I recommend the Draw-Tite Class III Max Frame # 76084. This is a custom fit trailer hitch which eliminates the need for drilling during installation because it uses existing holes in your vehicle's frame. I have attached an installation video for you to check out.

Next you will need a ball mount to use with your trailer hitch. Choosing the correct ball mount will depend on the trailer you are towing, so I have provided a link that takes you to our selection as well as a helpful article on the subject.

Lastly, you will need a wiring harness like the Curt T-Connector # C56040 to power the rear lights on your trailer. This is a custom fit harness that plugs directly into existing wiring on your vehicle. I have included an installation video on a 2014 Crosstrek for your review.

expert reply by: Chris R

0

Answer 1

The Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" #C11497 is a confirmed fit for a 2007 Subaru Impreza. It is rated for 200 lbs tongue weight but won't allow for the 2 inch opening for your motorcycle carrier. Using an…

view full answer...

Answer 2

According to EcoHitch, the hitch has a 525 lb tongue weight capacity. If the vehicle itself has a lower tongue weight capacity, you'll need to abide by whichever rating is lower. This hitch is a fit for the 2012-2016 Subaru Impreza Sedan,…

view full answer...

Answer 3

For your 2013 Subaru Impreza Sport 2.0 hatchback, I recommend the EcoHitch Invisi Trailer Hitch Receiver - Custom Fit - Class III - 2" #306-X7211 which is rated for up to 525 lbs tongue weight. You will need to subtract from that the weight…

view full answer...

Answer 4

Since your 2016 Subaru Impreza is a smaller vehicle there isn't a 2 inch hitch available for it. There are only Class I 1-1/4 inch hitches like the Curt #C11286. When we installed this hitch on a very similar 2014 Impreza we found that it…

view full answer...

Answer 5

According to the owner's manual for your 2012 Subaru Impreza, "Your vehicle is neither designed nor intended to be used for trailer towing. Therefore, never tow a trailer with your vehicle." With that being said, should you choose to…

view full answer...

Answer 6

There are several different methods you could use to route the power wire from Curt trailer wiring harness #C56259 to the battery on your 2016 Subaru WRX. The first step is to find the best exit point from the trunk/cargo area. There are 2 paths you…

view full answer...

Answer 7

The tongue weight capacity of the trailer hitch is one thing but you also have to consider the tongue weight capacity of your 2015 Chevy Equinox. According to the vehicle owner's manual the 4 cylinder models are rated for 1,500 pounds gross…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...