Replacement Velcro Strip that Slides into Channel on TruXedo Lo Pro QT/Original Edge Tonneau Covers

Question

Question:

2008 silverado crew cab, is this the part that slides into the bed rail pieces

asked by: Bill

0

Expert Reply:

Yes, Replacement TruXedo Shur-Bond Velcro Brand Fastener # TX1115174 slides into the rail on TruXedo Lo Pro QT or Original Edge tonneau covers. It is 80 inches long at 1-5/16 inches wide.

expert reply by: Michael H

0

Answer 1

Typically its the loop section of a Velcro strip that wears out before the hook side as the hooks are made of a harder material. The part #TX1115174 that you referenced comes with both sides though.

view full answer...

Answer 2

I spoke with my contact at Truxedo and she said the Replacement Truxedo Shur-Bond Velcro Brand Fastener, part #TX1115174 is 80 inches long by 1-5/16 inches wide. This part contains 2 fasteners.

view full answer...

Answer 3

The replacement Velcro-like fastener strips for your TruXedo Lo Pro QT tonneau cover on your 2010 Dodge Ram 1500 can be found listed as the Replacement TruXedo Shur-Bond Velcro Brand Fastener #TX1115174 on our site. The fastener is 80 inches long and…

view full answer...

Answer 4

The Replacement Truxedo Shur-Bond Velcro Brand Fastener Kit #TX1115174 comes with 2 of the hook-side Velcro fasteners that attach to the truck rails so you will need one kit. The mating (loop) pieces will already be on the tonneau cover. This kit…

view full answer...

Answer 5

The Replacement TruXedo Shur-Bond Velcro Brand Fastener for 6-1/2' Beds -1-5/16" Wide #TX1115174 is designed to fit TruXedo Lo Pro or Original Edge tonneau covers. While I can't say for sure whether or not these will fit a Tonno Pro I…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...