bing tracking image
Q & A Icon

Parts Needed to Flat Tow 1995 Jeep Wrangler with Falcon Tow Bar  

Question:

I have a falcon 5250 tow bar with the base assembly. I plan on towing a 1995 keep wrangler with stock bumper. What do I need? Thank you!

1

Helpful Expert Reply:

You will need the base plate kit part # 1409-3 which is confirmed to fit your 1995 Jeep Wrangler with a stock bumper and work with your Falcon tow bar.

For safety cables you can use # RM-643. The coiled design helps keep the cables off of the ground.

For lighting you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.

And finally, most states now require supplemental braking in the vehicle being flat towed. The easiest system to set up and use is the Blue Ox Patriot # BLU37TR, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.

Most likely you will also need a high low adapter so that the tow bar will be level when you are flat towing. I attached a link to a page that has all of the ones we carry.

I have included a couple of helpful links to our articles on flat towing for you. Be sure to consult the vehicle owners manual for more specific information on flat towing your vehicle.

expert reply by:
1
Jameson C

Products Referenced in This Question





Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>