Pipe Mount Swivel Jack Rated for 3K with 15 Inch Lift and Retracted Height between 12 and 14 Inches

Question

Question:

need a swivel pipe mount pipe jack with 3000 lb lift fully retrated height between 12 and 14 and 15 inches of lift

asked by: Ken D

0

Expert Reply:

For your needs I recommend Bulldog jack # BD190708. It is rated higher at 5,000 pounds but all that means is that it will be easier on the jack. It fits all of the other criteria you are looking for. The fully retracted height is 12-5/8 inches and it has 15 inches of lift. It is a pipe mount swivel jack and comes with the proper size mating pipe that gets welded on. I have linked a video of this jack for you.

expert reply by: Michael H

0

Answer 1

I have a solution for you but you're going to need to weld on a pipe mount. There are no jacks available that will clamp onto your frame and give you that much of a lift. The clamps won't support that much extension. For that high of a lift…

view full answer...

Answer 2

The distance from the center of the pipe mount to the top of the Square Pipe Mount Swivel Jack w Footplate #TJDP-7000-B measures 10-1/4 inches.

view full answer...

Answer 3

The retracted bracket height dimension of the 12-5/8 inches that the Bulldog Jack part #BD190708 that you referenced has is measured from the bottom of the foot to the center of the pipe mount bracket on the side of the jack.

view full answer...

Answer 4

The foot plate of the Jack part #PS1401480303 that you referenced can not be removed so there would be no way to rotate it 90 degrees. A better option for you may be the Bulldog Square Jack part #BD190708. The inner leg is removable. I attached a…

view full answer...

Answer 5

Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Topwind - 15-1/4" Travel - 7K Item #TJP-7002-B does not have a grease fitting. But there is a another option that does. Take a look at Square Pipe Mount Swivel Jack w Footplate - Drop Leg -…

view full answer...

Answer 6

Good news! I was able to get a exploded diagram as well as a set of instructions on how to replace the rod and gears #TJD-12000-RODNUT in the #12000 Series Ram Jacks made after 2012. I have attached them to this page for your convenience. Basically,…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

view full answer...