Does Superchips Programmer SU4845 Fit a 2016 Ram 1500 with 5.7 Liter Engine

Question

Question:

Hello Just wondering will this fit a 2016 ram 5.7 liter? If not do you have one that will ? Thank you for your time

asked by: Steve A

0

Expert Reply:

Yes, the Superchips Programmer part # SU4845 is a confirmed fit for your 2016 Ram 1500 with a 5.7 liter engine. The advertised power gains this programmer provides is 17 horsepower and 26 ft lbs of torque.

expert reply by: Jameson C

0

Answer 1

The Superchips Flashpaq part #SU3845 is going to be you best option for a programmer for your 2006 Dodge Ram 1500 with a 5.7 liter hemi. This gives you an additional 18 horsepower and 26 ft lbs of torque that will make towing easier.

view full answer...

Answer 2

Suspension enhancement systems, like the Super Springs #SSA28, can be used with weight distribution systems. However, Super Springs may not have much of an effect because a weight distribution system is going to be more effective at reducing sag…

view full answer...

Answer 3

Yes, the Reese Friction Sway Control Kit #83660 can be used with the Reese Pro Round Bar Weight Distribution #RE34FR. You may need to move the brackets back on the weight distribution hitch to get the ball for the sway control at its 24"…

view full answer...

Answer 4

Adding a Timbren system like the part #TFRTT1502D definitely would help, but it would not be an adequate replacement for your weight distributions system. Your weight distribution system distributes the tongue weight of your trailer to your front…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 11

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Does Superchips Programmer SU4845 Fit a 2016 Ram 1500 with 5.7 Liter Engine

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching