Could Curt Taillight Converter Box C59196 be Used to Convert Combined Taillight Circuits to Separate
Question:
I have a 2014 Jeep Grand Cherokee Overland. I am looking to make the combination brake/turn signal tail lights separate brake and turn signals. On this truck, there is a clear lens under the brake light that is a reverse light. Im planning on using a C56196, cutting the brake/turn wire, putting it through the converter, and hooking up the turn wire to the reverse light and put a yellow bulb in it. I know its not this products intended use, but do you think it will work? Thanks!
asked by: Evan S
Expert Reply:
The converter box part # C56196 that you referenced would work well for converting a combined taillight circuit to a separate one. Typically this is used on the trailer side of the wiring but there's no reason you couldn't use it on the vehicle wiring as well.
Product Page this Question was Asked From
Curt 2 to 3 Wire Tail Light Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Tow Bar Wiring
- Shop: Curt 2 to 3 Wire Tail Light Converter
- Shop: Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle w/ 2" Lift - 5 Bolt - 3.5K
- Shop: Vehicle to Vehicle Tail Light Converter
- Q&A: How to Get Separate Turn Signals and Brake Lights to Work on a Trailer
- Shop: Hopkins Tail Light Converter - LED Compatible
- Video: Curt Tow Bar Wiring C56196 Review
- Shop: Timbren Axle-Less Trailer Suspension w Idler Hubs - Standard Duty - No Drop - 5 on 4-1/2 - 3,500 lbs
- Video: Review of a Trailer Suspension Enhancement System - TASR35HDS07
- Q&A: Can I Add a Separate Turn Signal Light to My Trailer
- Search Results: grease
- Search Results: rims
- Video: Dexter E-Z Lube Axles Trailer Idler Hub Assembly Review and Installation
- Shop: Lionshead Trailer Wheel Lug Nut - 1/2"-20 - Stainless Steel - Qty 1
- Shop: Cotter Pin - 1/8" Thick x 1-3/4" Long
- Q&A: Recommended Timbren Axle Less System and Hub with 5 on 5-1/2 Bolt Pattern
- Q&A: Which Hubs Fit the Timbren Heavy-Duty Axle-Less Trailer Suspension # TASR35HDS06 with 2" Lift
- Q&A: Recommended Idler Hubs for Timbren Heavy-Duty Axle-Less Trailer Suspension 3,500 lbs
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Q&A: Troubleshooting Taillight Feedback When Using 2 to 3 Taillight Convertor
- Q&A: Curt 2 To 3 Wire Tail Light Converter Install
- Search Results: 2 wire to 3 wire tail light converter
- Article: Trailer Wiring Diagrams
- Video: Review of Hopkins Wiring - Trailer Connectors - HM48847
- Search Results: 3 to 2 wire converter
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Search Results: trailer brake controller
- Shop: Trailer Wiring
- Search Results: base plates
on Tow Bar Wiring
