Replacement Motor, Switch & Gearbox for 5th Wheel Landing Gear  

Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs #LG-217884 only will use one switch. If you were to use two motors, then dual switches would be used. I've attached a diagram to assist. The input wires from the battery can be…

Stromberg Carlson Follow Leg #LG-179014 and Lippert Follow Leg #LC179014 are basically the same. Stromberg Carlson purchases parts from Lippert so a lot of their products are nearly identical to each other.

It sounds like you might have an Ultra-Fab landing gear set. I have included a diagram showing how the system gets wired. On it the white wire is the power wire and the green wire is the ground.

Yes, the Lippert High Speed 5th Wheel RV Landing Gear Motor #LC141893 was/is completely interchangeable with the Stromberg Carlson LG-141893, which we no longer have available. These two units are the exact same motor just supplied by different…

A 14 oz container like the part #L11390 would be more than enough to grease your hubs. For a grease gun you would want part #L30200. Here's how to grease everything upon initial installation. First, grease your bearings and spindle by hand or…

The landing gear motor and the switch should not get hot like you are describing so it sounds like you may have another issue with your landing gear, such as the gearbox or some other component going bad. It sounds like you may have a rotten gearbox,…

If you wired your landing gear switch backward that should not have anything to do with your fuses blowing. Whether the switch is wired correctly or incorrectly the same amount of power is going through it to the jack motor. What is more likely is…

The Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs #LG-217884 you asked from is pretty straight-forward with the red and black connecting to the motor and the switch #LG-145236 having an additional pink and black wire. The pink…

This Stromberg-Carlson Motor and Switch Kit, part # LG-217884, is compatible with most brands of landing gear, including Lippert and Atwood. I spoke to my contact at Lippert, who manufactures the motor, and they confirmed that most landing gear that…

The Motor and Switch Kit for Stromberg Carlson Landing Gear #LG-217884 uses a crank shaft that is 5/8". I contacted the manufacturer about this and they informed me that the crank shaft used for this uses a 7/16" wrench. A 7/16" wrench…

It is very possible that the Motor and Switch Kit for Stromberg Carlson Landing Gear part #LG-217884 could fit Atwood Landing Gear Legs as most of these landing gear parts are interchangeable among brands.

If the replacing the gear box didn't fix the problem, then as long as the internals of the legs themselves are still in good shape replacing the motor would be the next logical step. Before doing that, I'd use the crank to operate the landing…