How To Wire A Landing Gear Switch On a 2007 Keystone Montana
Question:
I looked up your answer to a question of how to wire in a new switch for the landing gear controls but the picture does not show how to wire to the actual switch. Which wire goes to which wire plug in on the switch. Could you be lots more specific. Such as the main power wire goes to ???? And the orange wire goes to ???
asked by: Larry S
Expert Reply:
The Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs # LG-217884 you asked from is pretty straight-forward with the red and black connecting to the motor and the switch # LG-145236 having an additional pink and black wire. The pink wire goes to the battery positive terminal and the black wire coming from the bottom of the switch goes to ground either on the trailer frame or to the negative battery terminal which will be connected to the trailer frame. The middle wires on the switch are the black and red wires that go to the motor where depending on which one is powered will determine the direction the motor turns so the leg will raise or lower. I've attached a diagram to assist.
As far as the color of your wires on the motor, I recommend connecting the wire directly to 12v power with the other wire on ground to determine which is used to raise and then the opposite would lower it.
Products Referenced in This Question
Replacement Switch for Stromberg Carlson Electric Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Shop: Lippert Standard 5th-Wheel Landing Gear Motor w/ IP Rated Switch and Harness
- Shop: Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Shop: Suspension Enhancement
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Shop: Replacement Gearbox for etrailer and Ram 5th Wheel Landing Gear
- Shop: Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs
- Search Results: landing gear motor
- Q&A: Difference Between Stromberg Carlson and Lippert Replacement Landing Gear Follow Legs
- Shop: Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Shop: Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Q&A: Should Landing Gear Motor and Switch Get Hot on Fifth Wheel Trailer
- Q&A: Will the Motor and Switch Kit for Stromberg Carlson Landing Gear Fit Atwood
- Q&A: Will StrombergCarlson Landing Gear Motor, Part # LG-217884, Fit 2000 Cherokee Lite Fifth Wheel 25 RL
- Q&A: What Size Crank Shaft Does the Stromberg Carlson Motor and Switch Kit Use
- Shop: Timbren Rear Suspension Enhancement System
- Video: Stromberg Carlson Trailer Jack LG-119226 Review
- Video: etrailer and Ram 5th Wheel Landing Gear Replacement Crank Handle Review
- Search Results: landing gear crank
- Search Results: landing gear crank handle
- Video: Stromberg Carlson Trailer Jack LG-217884 Review
- Video: Review of Lippert Trailer Jack - Camper Jacks - LC196308
- Video: Stromberg Carlson Trailer Jack LG-179015 Review
- Video: Timbren Vehicle Suspension - Rear Axle Suspension Enhancement - TGMRTT35D Review
- Search Results: timbren
- Search Results: lg196308
- Search Results: lc196308
- Search Results: lg~196308
- Video: TruRyde Trailer Suspension TRSS300 Review