What Coupler Fits the Square Tube Trailer Jack TJDA-5000S

Question

Question:

Do you have a 2 inch coupler that is compatible with the jack code TJDA-5000S?

asked by: Robyn

0

Expert Reply:

The only coupler we offer compatible with the part # TJDA-5000S is the A-Frame Trailer Coupler w/ Square Jack Hole # CA-5280-QB which is designed for 2-5/16 inch hitch balls. Reason is due to the higher capacity nature that the jack and coupler have and the fact that 2 inch hitch balls just don't have the same towing capacities as 2-5/6 inch.

expert reply by: Jameson C

0

Answer 1

You could technically wire an electric trailer jack directly to your truck's battery, but that isn't really the most practical setup. I've seen one guy pull out his jumper cables every time he wanted to use the jack in this fashion, but I…

view full answer...

Answer 2

I do have a couple solutions for you but the Square A-Frame Jack #TJDA-5000S is not compatible with the round jack mounting hole on the Demco A-Frame Trailer Coupler #DM14793-52. For a trailer coupler that features a standard 2-1/4 by 2-1/4 inch…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

view full answer...

Answer 8

The 8-14.5 tires are an older metric size no longer used today. Therefore, you would need to replace these along with the wheels in order to update them. In order to see if we have any options for you, we'd first need to determine the bolt…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit and…

view full answer...