Repair Kit for Follow Leg of Venture 5th Wheel Landing Gear

Question

Question:

The landing gear motor on my 2004 Cherokee light 28BHS 5th wheel camper says Venture Mfg. Co. VMC940BB020862 Im not sure if thats a make and model for the entire landing gear setup or just the motor but Im trying to find a rebuild kit for the curbside jack.

asked by: Jason H

0

Expert Reply:

We have just what you need, the Lippert Components Venture Follow Leg Repair Kit # LC146060. If you ever need a lead leg repair kit we offer that too, part # LC146059. Both kits include bevel gears, drive shaft, pins and clips.

expert reply by: Adam R

0

Answer 1

The difference in the repair kits for your VMC900R will be the Drive Shaft; a lead leg kit will have a different shaped shaft than the follow leg. The replacement Landing Gear Kit for Venture Follow Legs is #LC146060, while the Lead Leg repair kit is…

view full answer...

Answer 2

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 3

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 4

The landing gear looks like a standard set based on the pictures and the dimensions you listed. The part #LC146060 would be what you need for the follow leg and then part #LC146059 for the lead leg.

view full answer...

Answer 5

In order to rebuild the gears inside your landing gear legs you'll need the Lippert Components Venture Repair Kit for 5th Wheel RV Landing Gear part #LC146060 for follow leg or part #LC146059 for lead leg.

view full answer...

Answer 6

To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions for the entire kit for the replacement gear and shaft kit for your Venture landing gear leg. The instructions…

view full answer...

Answer 7

I went to our warehouse and measured one of the part #C16902 pins for you. I have attached a photo that has the dimension you were asking about. As the photo denotes, the useable length on the pin is 3.56 inches. You might want to measure the pin you…

view full answer...

Answer 8

Thanks for the photo as well as the description you offered. The Follow Jack Repair Kit for Stromberg Carlson Landing Gear #LG-146060 is the correct fit for your 2010 Coachmen Brookstone 341RE.

view full answer...

Answer 9

Actually on brake magnets for trailers either wire can be used as the power or the ground so the colors don't really mean anything. Most likely the magnet manufacturer just put what ever color was most convenient on your trailer.

view full answer...

Answer 10

Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…

view full answer...

Repair Kit for Follow Leg of Venture 5th Wheel Landing Gear

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching