2016 Georgetown 351DS Brake Controller Recommendation

Question

Question:

Im looking for some information on how to install a brake controller on a brand new Georgetown RV. The RV already wired it came with a hitch and a big trailer plug in the back if it is already wired where is the connector for the controller located? Is it just a plug and play or do I have to run wires back to the already installed plug. Also what is the best brake controller system to buy

asked by: John

0

Expert Reply:

The correct brake controller install harness for your 2016 Georgetown 351DS RV is the part # 3034-P if you were to use a brake controller like our best selling Prodigy P3 part # 90195.

The wiring adapter would plug into the connector located behind the coin tray, as shown in the video I've linked for you. Fast forward to the 4:35 minute mark, and you can see where the connector is located.

expert reply by: Jameson C

0

Answer 1

I am not entirely sure what process you took so I'll give you some other things to try, or maybe a different way to test the Prodigy P3 #90195. First, sever the blue wire a couple inches from the back of your controller. Then use a circuit tester…

view full answer...

Answer 2

The #90195 P3 and the #39510 are both proportional controllers, so if you're testing for brake controller output with the brake pedal is pressed, you're not going to see any voltage with the brake pedal unless the vehicle is in motion. You…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

2016 Georgetown 351DS Brake Controller Recommendation

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching