Recommended CE Smith Post-Style Guide-Ons For Boat Trailer

Question

Question:

Should I use the ce smith 40 inch post guides or the 60 inch post guide ins for my boat and trailer was just looking for advice before go buy asset

asked by: William

0

Expert Reply:

The guide-ons you choose for your boat and trailer really depends on the height of your boat.

For a low-profile boat like a fishing boat or a Jon boat I recommend using the 40-inch tall guides, part # CE27620. If you have a taller boat like a cabin cruiser or a deep V hull boat I recommend the 60-in guides, part # CE27640.

expert reply by: Jeffrey L

0

Answer 1

No customers have said specifically they were using CE Smith guide-ons #CE27620 for a Whaler Classic Montauk. The overall height from the top of the pipes all the way down to where the metal support arm starts to turn towards the trailer is 46-1/2…

view full answer...

Answer 2

the CE Smith guide-ons #CE27610 are approximately 15 degrees off 90 degrees. So that would be 75 or 105 degrees depending on which way the guide-on was facing.

view full answer...

Answer 3

The best way to determine the height needed is to measure from the top of your trailer frame to the top of the sides of your boat. If the 40" Tall Guide-Ons #CE27626 sit right at or slightly above the sides of your boat then the shorter…

view full answer...

Answer 4

Your surge coupler will have either a sticker or an engraving on it, typically near where the coupler is located. If you can get me that information and what you're needing to replace on it I'd be more than happy to help you find…

view full answer...

Answer 5

The dimensions of the Replacement Upright for CE Smith Bunk-Style Guide-Ons #CE27605PG are 39 inches tall by 23 inches long. The tube is 1-1/2 inches and the bend is a 90 degree angle. I've attached a picture for you as well.

view full answer...

Answer 6

It sounds like you'll need to do some fab work in order to get the guide-ons to work. I believe your best bet would be to eliminate the u-bolts and have the brackets welded to the top or the underside of the frame member. If the fender step…

view full answer...

Answer 7

You could flip the CE Smith Post-Style Guide-Ons for Boat Trailers #CE27620 mounting bracket upside down and just shoot some self-tapping screws through the diamond plate step, but this wouldn't provide as much strength for the posts in the…

view full answer...

Answer 8

The correct replacement actuator for your UFP 34034 is the Dexter DX7.5L A-60 part #DX56FR.

view full answer...

Answer 9

I took the picture you sent in and put the dimensions you are looking for on them. I attached the dimensions to this page for you to check out as well.

view full answer...

Recommended CE Smith Post-Style Guide-Ons For Boat Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching