How Does a Brake Controller Install in a 2004 Workhorse RV
Question:
Do you carry a Harness to connect a Prodigy P3 brake controller to a 2004 Workhorse RV chassis? Thanks!
asked by: Russ
Expert Reply:
There isn't a brake controller wiring harness for the 2005 Chevy Workhorse RV chassis. It is possible that the RV came with one. Sometimes they plug in under the driver's seat but would otherwise be located under the dash. It is also possible that it does not have a place to plug a brake controller into and could just have tow package wires under the dash. To check this look for a bundle of wires up under dash with a white tag on them.
If you cannot locate a wire bundle or place that a brake controller plugs into you will have to hardwire in the brake controller. The white wire is ground, black is 12 volt power, blue is output to the trailer brakes and red is input from the brake switch.
The white wire needs to attach to the negative battery terminal. Black goes to the positive battery terminal via a 30 amp circuit breaker. Blue connects to the back of the 7-Way in the 7 o'clock position. And red is input from the brake switch.
We have a kit # 5506 that comes with wire and circuit breakers. But you will like need more wire, # 12-1-1 which is sold by the foot, since RVs tend to be long.
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Products Referenced in This Question
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Dome for Ventline E-Z Lift Ventadome Trailer Roof Vent - Smoke
- Search Results: bve0108~03
- Q&A: Installing Trailer Brake Controller on 2004 Workhorse Chassis
- Search Results: rvk3500
- Search Results: 94239
- Shop: Replacement Check Valve/Vacuum Breaker for Factory RV Tank Flushing Systems - 1/2" MPT
- Shop: Everchill RV Refrigerator w/ Freezer - Reversible Doors - 10.7 cu ft - 12V - Stainless Steel
- Shop: Lippert Replacement Standard Bearing Block Kit for RV In-Wall Slide-Out
- Search Results: 65528
- Search Results: 146~7
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Q&A: Everchill Model WD-282FWDC-B-6 RC refrigerator
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring
- Search Results: trailer jack
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Choosing the Right Brake Controller
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: hitch
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Article: Trailer Tire Sizing
- Shop: Suspension Enhancement
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: Brake Controller
- Article: How to Measure for Trailer Hitch Drop
- Video: Ventline Ventadome Replacement Vent Installation
- Article: How to Measure Your Trailer Wheel Bolt Pattern