Which Firestone Air Suspension Kit is a Fit for a 2007 Chevy Silverado 3500 Classic Body

Question

Question:

Will this system fit a 2007 3500 LT Classic dually?

asked by: Jay

0

Expert Reply:

If your 2007 Chevy Silverado 3500 is a 2 wheel drive model then yes the Firestone kit part # F2700 that you referenced is a confirmed fit that would work well.

If instead you have a 4 wheel drive model you would want the part # F2250 instead which I attached an install video for.

expert reply by: Jameson C

0

Answer 1

For the weight you are pulling with your 2007 Chevy Silverado 2500 short bed 4x4 Duramax, I recommend the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs - Rear Axle #F2700. These air springs are adjustable from 5 psi to 150 psi and…

view full answer...

Answer 2

We have a Firestone Ride Rite Red Label air bag kit that fits your 2005 Dodge Ram 2500 with the part #F2701 which has the capacity of up to 7,500 lbs of additional support. For as much pin weight as you mentioned having this would be the kit to use…

view full answer...

Answer 3

We typically only recommend front suspension enhancement products for vehicles with heavy brush guards/winches or snow plows, but with a heavy camper in your truck bed, using a front SumoSpring Solo application would be an excellent idea. You'll…

view full answer...

Answer 4

If a 1000 lb round bale is the heaviest thing you'll haul in the truck bed, I'd recommend going with the SumoSprings #SS95MR that you'd looked at, which would provide you a little bit of leeway in case the bales vary in weight a bit as…

view full answer...

Answer 5

Yes, the Timbren Rear Suspension Enhancement System #TGMRCK35S can still be used on your 2007 Chevy Silverado even though its been lifted. You'll just need to install a spacer to get the gap between the Timbren and the axle around 1" to…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...