Does FHG72VR Brake Light Hitch Cover Blink w/ Turn Signals

Question

Question:

Some do and some don't. My question is do the turn signals flash on the Flint Hill Goods Square LED Brake Light Hitch Cover for 2" HitchesItem # FHG72VR

asked by: Lyle

0

Expert Reply:

The Flint Hill Goods Square LED Brake Light Hitch Cover for 2" Hitches # FHG72VR does not blink with the turn signals. It only works with the running lights and brake lights.

expert reply by: Mike L

0

Answer 1

The most likely cause for the incorrect behavior of your trailer lights, where activating one turn signal causes all trailer lights to blink, is an insufficient ground (or a short to ground) on either the vehicle or the trailer. Since you re-wired…

view full answer...

Answer 2

The brighter illumination of the Flint Hill Goods Square LED Brake Light Hitch Cover for 2" Hitches #FHG72VR that you referenced will bypasses the turn signals and only flashes with brakes.

view full answer...

Answer 3

We have many lighted hitch covers and I have included a link to them to the right for you. None specifically have the Land Rover name or logo but there are other options depending on what you are looking for. The most popular option is the Flint Hill…

view full answer...

Answer 4

This sounds like a ground issue or a possible short. Ground problems normally show up when there is more draw on a system such as when you have the running lights on and then use another function like a turn signal or brake light. A short could come…

view full answer...

Answer 5

Your brake lights and turn signals for each side are on one circuit. The left side turn signal and brake light is generally the yellow wire going into your trailer connector. The first thing to do is check the fuses on your tow vehicle. Next, inspect…

view full answer...

Answer 6

Sounds like you got some "bulb out" error messages when you installed the LED hitch cover previously. The reason for this is the slight amperage draw of the cover tells the computer of your truck that there is a problem with the taillights.…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 11

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 12

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Does FHG72VR Brake Light Hitch Cover Blink w/ Turn Signals

Featured Help Information

Miscellaneous Media

Continue Researching