Can the Race Ramps # RR-TR-5 Be Used with Nissan 370Z that is 5-1/2 inches Off Ground

Question

Question:

How do I figure out if these are the correct ramps? Car is 5 1/2inch off ground at nose. Trailer is 18 ft. beaver tail. Thanks in advance.

asked by: Tony I

0

Expert Reply:

The overall height of the Race Ramps Trailer Ramps # RR-TR-5 is 5 inches, the length of the ramp is 67 inches, and the angle of the ramp is 4.3 degrees. Your vehicle that sits 5-1/2 inches off the ground would easily fit without scraping.

If your trailer's dovetail is 5 inches off the ground or has ramps that would work well at that height these would be great for you.

expert reply by: Jameson C

0

Answer 1

In order to make this work I am recommending two sets of ramps, but you will only be using three of the four ramps. The first ramps I recommend are the Race Ramps Trailer Loading Assist Ramps - 5" Lift - 67" Long - Qty 2, part #RR-TR-5.…

view full answer...

Answer 2

For getting your trike up onto a trailer, using the #288-07452-2 along with the #288-07452 ramps as you've proposed would be the best bet, and would be what I'd recommend. The combined capacity of the ramps would handle the weight of your…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

I attached a picture that shows the pin out diagram for the Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole #PK11893-11932 that you referenced.

view full answer...

Answer 5

Yes, so long as you have a standard a-frame trailer you will be able to replace your current welded on coupler with the Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Zinc - 2-5/16" Ball - 21K item #DM13205-95. I have attached…

view full answer...

Answer 6

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 7

As long as your trailer weighs less than 6,000 lbs the FlatStoppers part #RR-FS-10 that you referenced would work well to prevent your trailer tires from getting flat spots. You would just need to get all 4 wheels of your trailer up onto the…

view full answer...

Answer 8

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 9

The trick for hanger spacing is to subtract around 3/8 of an inch from the spring length (eye to eye) and then use that dimension for the hanger spacing on a single axle trailer. So for a 23-1/8 inch long leaf spring a spacing of 22-3/4 inches would…

view full answer...

Can the Race Ramps # RR-TR-5 Be Used with Nissan 370Z that is 5-1/2 inches Off Ground

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching