Enclosed Door Latch Recommendation for a 1 inch Thick Door

Question

Question:

I am looking for a door latch for side door of an enclosed cargo trailer that I can open from the outside and inside. 1inch thick wall

asked by: Bradley

0

Expert Reply:

Sounds like you are looking for something like the Locking Stainless Steel Flush Door Latch # L3980 as this is the common door latch you see on the side doors of enclosed trailers and can be used on doors that are 1 inch thick like yours.. I attached a review video for you to check out as well.

You will also need the # 4PLSP to open the door from inside.

expert reply by: Jameson C

0

Answer 1

I have a solution for you, but the "Junior" Locking Stainless Steel Flush Door Latch with Inside Release #L1833 that you referenced can only fit doors up to 7/8 of an inch in thickness. For your 1 inch thick door you would want the…

view full answer...

Answer 2

The closest thing we offer to Bargman 99 Incandescent Clearance Light #3499001 that you referenced that is an LED would be the Optronics Trailer Lights #MCL63RB. Dimensionally these lights are virtually identical. I attached a review video for this…

view full answer...

Answer 3

I went out to our warehouse and measured the T-Strap Hinge for Side and Rear Trailer Doors #PLR3408. The distance from the center of the mounting hole to the center of the closest strap hole is 3 inches. The distance from the center of the 1/2 inch…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 6

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 11

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Enclosed Door Latch Recommendation for a 1 inch Thick Door

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching