Where Is Tornado 360-Degree RV Holding Tank Rinser Installed On Holding Tank

Question

Question:

Do you install the tornado 360 on the bottom of the tank in the center?

asked by: Scott

0

Expert Reply:

Per the installation instructions, the best place to mount the Tornado 360-Degree RV Holding Tank Rinser, part # CAM40126 is on the opposite end of the flush valve.

You can use the template included with the Tornado and measure down about 2 inches from the top and in the middle of the tank. Then tape the template to the tank and drill the mounting holes and center hole for the Tornado to be inserted into the tank, using silicone sealant to make sure there are no leaks.

expert reply by: Jeffrey L

0

Answer 1

The Valterra Clog Killer Tank Wand System #VAL28VJ is designed to be fed into toilet or drain from the inside. It should not be fed into the black tank from the outside. If you want to clean out the black tank with a hose from the outside you can add…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 4

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

You made a great choice in the Lippert Components Power Stabilizer Trailer Jack. For starters, all of the jacks measure to be 70-1/2" long with a 3,500 lb weight capacity and have a 30" lift. The difference between them is in regards to…

view full answer...

Answer 7

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 8

It sounds like when the Redarc Tow-Pro Elite Brake Controller #RED44FR was installed on your 2022 Toyota Highlander that they may have damaged the brake signal wire or tied into the wrong wire. I recommend taking it either back to the shop who…

view full answer...

Answer 9

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Where Is Tornado 360-Degree RV Holding Tank Rinser Installed On Holding Tank

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching