Air Suspension Recommendation For 2014 Dodge Ram 1500 Truck With 6 Inch Lift

Question

Question:

I have a 2014 Dodge Ram 1500 that I would like to put airbags on. It has a 6 inch skyjacker lift and I was wondering what I would need to do to put that on. Thanks

asked by: Cory F

0

Expert Reply:

We have just what you are looking for suspension enhancement on your 2014 Ram 1500.

I recommend the Air Lift LoadLifter 5000 Air Helper Springs, part # AL57365. This system lets you adjust the air pressure in the air bags individually so you can maintain an even level, even when carrying off-center loads.

Since you have a 6-inch lift on your truck you will also need spacers, part # F2375. When installing the system, the spacers go between the air springs and the mounting brackets.

An air suspension system will not increase the load-carrying capacity of your vehicle and should be used with a suspension system that is in good working order.

To adjust the level of air you keep in the air bags I recommend a compressor system like part # AL25980. This is a wireless system and you can adjust the level of air from the comfort of your truck cab.

expert reply by: Jeffrey L

0

Answer 1

If the rear end of your vehicle sags significantly when the trailer is hooked up then you could have an unsafe condition and your front end and tires will not wear properly. The weight is taken off of the front wheels of the vehicle and can cause…

view full answer...

Answer 2

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Both the Timbren Rear Suspension Enhancement System #TDR1500DS and #TDR1500DQ that you referenced are designed to fit the 2011 Ram 1500, but there are a couple differences that may factor into which set will work for your specific model Ram and…

view full answer...

Air Suspension Recommendation For 2014 Dodge Ram 1500 Truck With 6 Inch Lift

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching