Brake Controller and Harness Recommended for a 2011 Winnebago Vista P26 on Ford F53 Chassis

Question

Question:

2011 Winniebago Vista P26 with Ford V10 engine I need a brake controller and the harness to hook into the prewired vehicle brake system.

asked by: Ricky A

0

Expert Reply:

Your 2011 Winnebago Vista P26 was built on the Ford F-53 chassis. This is good because there is a brake controller wiring harness for this chassis. It is # 3035-P. The connector on the vehicle this harness plugs into is located up under the dash behind the instrument cluster, see picture. It is a little difficult to reach but I'm sure you can do it!

For a brake controller I recommend the P3, # 90195, because it offers excellent user-friendly features such as easy to read and understand diagnostics. I have linked a video review of this controller for you.

expert reply by: Michael H

0

click to enlarge

Answer 1

We sure do! The etrailer Electric Trailer Brakes item #AKEBRK-35 work with 3,500 lbs axles that have a 4 bolt mounting flange. These left and right 10" x 2-1/4" assemblies have rust-resistant, e-coated backing plates that work with 15"…

view full answer...

Answer 2

Since you already have a factory 4-way flat on your 1996 Ford F-350 you will need the Adapter 4-Pole to 7-Pole #37185. This will plug into your factory 4-way and the rest of the wiring will have to be spliced into your factory wiring as I do not see…

view full answer...

Answer 3

To install your Reese Pod brake controller in your 2018 Ford Explorer will require the install harness part #3035-P which is a confirmed fit. If you check out the 9:55 mark of the install video I attached to this page you'll see where to find the…

view full answer...

Answer 4

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 5

Your 2014 Fleetwood Bounder should be on a Ford F-53 chassis. If you found the gray plug next to the brake release (see attached photo) then this means that you should just be able to use a plug-in adapter to easily install your brake controller. Out…

view full answer...

Answer 6

On the 2014 Ford F-53 chassis the brake controller port is located on the left hand side of one of the steering column supports. The plug is gray in color, and you should be able to see it if you look to the right of the emergency brake release…

view full answer...

Answer 7

Thank you for reaching out and for the photos! We try to carry over the wiring brackets and for a long time they didn't change which is why we carried it over. With this new information we will definitely be updating our website. For your…

view full answer...

Answer 8

A factory 7-way trailer connector isn't all you need to power a trailer's electric brakes. You still need a brake controller. Some Ford F-150s are equipped with a factory integrated brake controller, which you may have. If your 2012 Ford…

view full answer...

Brake Controller and Harness Recommended for a 2011 Winnebago Vista P26 on Ford F53 Chassis

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching