Will the etrailer Hub part # AKHD-865-7-2-EZ-K Fit Behind a 16 inch Wheel

Question

Question:

AKHD-865-7-2-EZ-K Does this work with 16 inch wheels as well as long as they have the 8x6.5 lug pattern. For some reason it displays only 17inch and up

asked by: Jake L

0

Expert Reply:

Certain hub/drums are so large in diameter that they won't fit behind a smaller wheel. The part # AKHD-865-7-2-EZ-K that you referenced can fit with a 16 inch wheel that has a 8 on 6-1/2 inch bolt pattern though.

I attached a review video for this hub for you to check out as well.

expert reply by: Jameson C

0

Answer 1

Hi Chad! There are 2 ways to tell the difference between driver side and passenger side Dexter Axle brake assemblies; the first is by looking at the sticker on the inside, and the second is by looking at the brake assemblies as a whole. For…

view full answer...

Answer 2

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 3

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 4

We have that size (see link), but none of the tires are radial. They are all bias ply as that is the common construction for the LT tires. The closest tire size that is radial would be the 235/80R16 like part #TTWTRTM2358016E. This size has a…

view full answer...

Answer 5

For your 1st question, yes the Dexter Nev-R-Adjust Electric Trailer Brakes #23-464-465 are going to fit the 5 bolt mounting flange on your 7,000lb axle for your 2020 Grand Design Solitude 380FL. For your 2nd question, yes the Trailer Hub and Drum…

view full answer...

Answer 6

The Dexter Electric Trailer Brake Assembly #23-429 & #23-428 have a center opening of 3-7/8" for fitting on the axle tube. It will mount to bolt holes that are 3-5/8" spread left to right and 4-3/8" top to bottom. I have included…

view full answer...

Answer 7

I saw the Q&A you were referring to, which is about a decade old as of this writing and there are no 12" diameter x 3-3/8" wide brake assemblies we offer, just the 12-1/4" diameter x 3-3/8" wide #AKEBRK-8 that are rated for…

view full answer...

Will the etrailer Hub part # AKHD-865-7-2-EZ-K Fit Behind a 16 inch Wheel

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching