What is the Correct Inflation for Karrier Trailer Tire # AM32739 and is it Mounted and Balanced

Question

Question:

I understand that the maximum load is at 95 psi. what is the proper inflation with a load of 2200 lbs per tire? Also, are the tires delivered mounted and Balanced?

asked by: Chuck

0

Expert Reply:

The tire, # AM32739, should be inflated to 95 psi regardless of load size. The problem is that under inflating a trailer tire will lead to degradation of the tire. On trailer tires, the side walls are thicker than on car tires so they can handle more vertical load. An under inflated tires side walls will heat up more often and quicker and will lead to early wear and possible failure of the tire.

The tire and wheel combinations, like the Karrier ST235/85R16 Radial Trailer Tire with 16 inch White Wheel, # AM32739, do come mounted, but not balanced.

expert reply by: Michael H

0

Answer 1

For a general-purpose safety chain for a standard gooseneck trailer we offer #337BSC3842 from Buyers Products. This is a 42-inch chain with 3/8-inch clevis. The chain is rated for 15,000 pounds. This is sold as a single chain, not a pair. The 36-inch…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 6

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 7

The first thing you will need for your 1999 D250 is a 4-way. The Curt T-Connector Vehicle Wiring Harness #C55317 plugs into the connection points behind your rear bumper and will allow you to power your trailer's signal lights. Once the 4-way is…

view full answer...

Answer 8

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 9

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 10

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 11

There is a retainer bolt in the wheel carrier that holds the bushing and king pin in place in the Demco Kar Kaddy SS #DM9713045. You would need to remove the retainer bolt to release the king pin and replace it. This is a part that we do not…

view full answer...

Answer 12

Since you have a drop axle, you could change it over to a straight spindle axle in order to gain 4 more inches of ground clearance. In order to get a new axle, some measurements of your current axle are needed. You will want to measure hub face to…

view full answer...

What is the Correct Inflation for Karrier Trailer Tire # AM32739 and is it Mounted and Balanced

Product Page this Question was Asked From

Continue Researching