What Metal is the Dexter Hub # 84555UC1 Made of

Question

Question:

Hi What material is the hub made from? I want to make a wheel carrier and I need to weld onto the hub, is it possible? I also need a spindle with a square shank, do you have for this hub? Thanks

asked by: Steven C

0

Expert Reply:

I spoke with my contact at Dexter and they told me that their hubs are construct of cast iron.

Cast iron is difficult, but not impossible to weld. For a square spindle to fit this hub you would want the part # TRU47FR.

expert reply by: Jameson C

0

Answer 1

TruRyde Spindles are indeed compatible with Dexter hubs, if the spindle is matched properly with the bearings your hub uses. To find the correct spindle, match the inside diameter of your inner bearing, outer bearing and grease seal to the…

view full answer...

Answer 2

I spoke with my contact at Dexter and they told me that their hubs are construct of cast iron. The trailer hub you referenced, part #84545BX, includes the inner bearing and race, lug nuts, outer bearing and race, grease cap and grease seal. This…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are…

view full answer...

Answer 5

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 6

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

Depending on how the trailer was made, there will be a few spots you can check to identify the axle. First, if the trailer was pre-made by a specific company, you may be able to find this information in either the paperwork or on a placard somewhere…

view full answer...

Answer 10

Overpacking the trailer hub with grease is the number one reason for grease seal failure. For a boat trailer I would recommend re-packing the hubs by hand with grease once per season and you'd be fine. I don't like recommending people use…

view full answer...

Answer 11

To determine if there are compatible hubs and associated bearings to replace your current hubs to a more standard size you will have to take several precise measurements on the spindle of your axle. It is recommended to use a set of dial calipers to…

view full answer...

Answer 12

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

view full answer...