How To Relocate Leaf Springs Above Trailer Axle for More Ground Clearance
Question:
On a normal setup with a 3500# axle, typically the axle is bolted to the top of the leaf spring. Can that be turned over, such that the axle is on the bottom of springs, giving me a little more fender clearance? I am concerned that the center pin may not fit, or something like that. The axle is a straight axle, not a axle or anything. Thank you.
asked by: Steve R
Expert Reply:
Relocating the leaf springs from the underslung to the overslung position is very commonly done. Some folks refer to it as flipping the axle, which is a misnomer. You wouldn't want to actually flip the axle, because the axle has a slight upward bow or curve in it to provide the proper wheel camber. You'll be leaving the axle in its current configuration, but relocating the leaf springs.
A 3500 lb axle will usually be 2-3/8 inches in diameter. If that's the case with your axle, you can use the Dexter Over-Under Axle Conversion Kit, part # K71-384-00. These kits include new U-bolts and two new spring seats that should be tack welded into place. The kit is intended for use with double-eye suspensions only.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Product Page this Question was Asked From
U-Bolt Plate for 2-3/8" Round Axle - 1-3/4" Wide Springs - 1/2" Bolts - Galvanized
- Trailer Suspension Parts
- U-Bolt Plates
- Boat Trailer
- Snowmobile Trailer
- 3500 lbs
- Round Axle - 2-3/8 Inch
- 1/2 Inch Diameter
- Redline
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Q&A: Parts Needed to Convert Overslung Trailer Axle to Underslung
- Video: Dexter Trailer Springs Over-Under Conversion Kit Installation K71-384-00
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Video: Dexter Axle Trailer Suspension - Leaf Spring Suspension - K71-384-00 Review
- Q&A: What is Difference Between Overslung and Underslung Trailer Coupler
- Q&A: Can Leaf Springs be Moved to Top of Underslung Axle
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Is it Difficult to Move Axle From Above Springs to Below Springs
- Q&A: Will Switching From a Drop Axle to a Straight Axle Increase Tire Clearance
- Q&A: Moving Leaf Springs from Below the Trailer Axle to the Top of the Axle
- Shop: Replacement Spring Seat for Dexter Trailer Springs Over-Under Conversion Kit - Qty 1
- Shop: Replacement U-Bolt with Nuts for 3" Round Trailer Axles - 1/2" Diameter
- Search Results: awning
- Shop: Replacement U-Bolt Axle Mounting Hardware Kit - 3" Axles
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat - Manual Lift - 10 Speed - Smoke
- Shop: Sleeve-Lock A-Frame Trailer Coupler - Flip Latch - Black - 2-5/16" Ball - 12,500 lbs
- Search Results: rv awnings
- Search Results: coupler
- Search Results: solera awning
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Shop: Trailer Hitch
- Article: How to Raise Your Travel Trailer Height
- Search Results: 25580
- Shop: Trailer Wiring
- Video: etrailer Trailer Axle 4-Leaf Double-Eye Spring Installation
- Search Results: dust caps
- Search Results: leaf springs
- Article: How to Accurately Measure Trailer Leaf Springs