Differences in Tow Ready and Hopkins Wiring Harnesses for Mazda B Series Pickup

Question

Question:

Whats the difference between wire harness 118325 vs Hopkins 40215?

asked by: Tom

0

Expert Reply:

The main difference between the Tow Ready # 118325 and the Hopkins # 40215 wiring harnesses is that the Hopkins # 40215 requires the harness to be grounded to the vehicle with the included self-tapping screw. The wiring harness needs to be grounded at a location where the sheet metal is doubled.

I recommend the Tow Ready T-One Vehicle Wiring Harness # 118325. This harness will have a much simpler installation since there it is a true plug-and-play wiring harness. Since the ground wire doesn't need to be attached to the vehicle frame, you will only need to plug the harness into the factory wiring system to install the harness.

If you can let me know the year of your Mazda B3000-series Pickup I will be happy to confirm if this wiring harness is a fit for your vehicle.

expert reply by: Victoria B

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

If your 1994 Ford Ranger does not currently have any trailer connector, the simplest way to install a 4-Way plug would be to use custom plug-in wiring harness #118325. This harness would be installed at the factory connector that is located…

view full answer...

Answer 4

Thank you for the photo that was helpful; on some models of Ranger drilling is required, but based on your photo, you will not have to drill in order to install the Draw-Tite hitch you asked about, which is the following part number: - Draw-Tite…

view full answer...

Answer 5

It is difficult to identify what hitch fits just by looking at the holes in the frame. However, I can tell you that the Curt Trailer Hitch Receiver #13138 is confirmed to fit your 2004 Ford Ranger Edge. This is a Class III hitch with a 2"…

view full answer...

Answer 6

The 1997 Ford Ranger has separate turn signals and brake lights. Trailer lights have combined brake lights and turn signals. What you will need to do is use trailer wiring harness #118325 which plugs into the factory tail light connectors on the…

view full answer...

Answer 7

It does sound like the converter box has shorted out and you would need to replace it with the part #118496 which is correct fit for your 2011 Toyota Tacoma. If the blinker circuits are still functioning on the trailer wiring but the brake light…

view full answer...

Answer 8

I am a little confused by what you mean. If the factory relay located in the fuse box on your 1993 Ford Ranger has burnt up when the trailer wiring was connected then you have a short in one of the circuits. In order to fix this you would need to…

view full answer...

Answer 9

If the vehicle you are towing with has separate stop and turn signals then it will need to be wired with a Modulite converter so that it can run the lights on the vehicle you are towing that does not have separate turn signals and stop lights. If the…

view full answer...