Can Different Brand Electric Trailer Brakes be Used on a Dexter Axle  

Most 5-bolt brakes use flange #4-44-1. That's not to say that there aren't some oddball or older styles that might have had a different 5-bolt pattern but the vast majority are going to use what could be considered as the standard. I included…

Yes, you can use the Dexter Electric Trailer Brake Kit - 12" - Left and Right Hand Assemblies - 7,000 lbs item #23-180-181 on your 5,200 lbs axle so long as you have a 5 bolt flange like the one linked in the diagram below. These brakes fit a…

You want to adjust your new brake assembly, like part #23-105-106, so that when you spin your tire/wheel you feel a little bit of drag. If you don't have any drag then your trailer braking will be weak but if you have a lot of drag then your…

Typically trailers will carry more of their weight on the front of the trailer, so you would want to put the brakes on the front axle as it will most likely carry more weight while braking. Also, when braking, weight will shift forward from the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part #AKEBRK-35-SA (3,500 Axles) Dexter…

Based on the GVWR of your 2019 Jayco North Point 315RLTS it does seem like you have 7k axles. I recommend verifying this information to be sure. These axles typically use the #14125A outer and #25580 inner bearing found in the Timken #TMK92VR.…

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…