Troubleshooting Tire Wear On Outside of Front Trailer Tire
Question:
My 35 ft. 5th wheel all of a sudden started to wear the right front tire on the outside edge, what would cause this? I have put alot of miles on this camper and just all of a sudden this started. Any help would be appreciated. Thanks
asked by: Royce H
Expert Reply:
Typically, when the outside edges of a tire are showing wear its because the tires are under-inflated. The solution is to inflate the tires to the maximum pressure listed on the sidewall in this situation.
Check the suspension for worn out components or holes that are egg-shaped instead of round where the suspension components come together. Rusty components won't necessarily hurt the way the tires wear, but you should still check them.
Product Page this Question was Asked From
Square BT8 Spindle for 2,000-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- 1-1/2 Inch Diameter
- Square
- For 2000 lb Axle
- TruRyde
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Search Results: spindle
- Video: etrailer Trailer Hubs and Drums - Hub - AKIHUB-545-2-G-1K Review
- Q&A: Are The AKIHUB-545-2-G-1K Idler Hubs Sold Individually Or As A Pair
- Video: Review of ABS Fasteners 1-3/4 Castle Nut Cotter Pin - 165649
- Shop: Square BT8 Spindle for 2,000-lb Trailer Axles - 1-1/2" Wide
- Shop: Cotter Pin - 1/8" Thick x 1-3/4" Long
- Shop: CE Smith Trailer Axle Beam with Standard Spindles - Galvanized - 57-1/2" Long - 1.8K
- Shop: BTR E-Z Lube Spindle w/ Brake Flange for 2,500-lb Trailer Axles - 1-3/4" Diameter
- Q&A: Process for Changing a Damaged Spindle on a Trailer Axle
- Q&A: How to Find Which Replacement Axle, Slipper Springs and Hubs are Needed for Small Boat Trailer
- Q&A: Can Damaged Axle on 1999 Shorelander Boat Trailer Be Sanded Smooth
- Q&A: Do Trailer Bearings Fit Tight To the Spindle they Install On
- Q&A: Can a Trailer Spindle with Grooves Still be Used if Bearing Fits
- Shop: Dexter Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2 - Galvanized
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Article: Trailer Wiring Diagrams
- Search Results: 44649
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Wiring
- Search Results: 68149
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Fifth Wheel Hitch
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Article: Trailer Tire Sizing
- Search Results: 25580
- Search Results: dust cap