Do Trailer Bearings Fit Tight To the Spindle they Install On
Question:
How tight does the bearing need to fit the spindle?
asked by: Eric
0
Expert Reply:
Bearings fit pretty tight onto spindles. There basically should be no play at all between the inner portion of the bearing and the spindle. They don't fit so tight that they would have to be pressed on, but they sometimes can be tight enough that they require a bit of effort to get them totally slid on.
Check out the install video I attached for more info on how bearings install.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Square BT8 Spindle for 2,000-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- 1-1/2 Inch Diameter
- Square
- For 2000 lb Axle
- TruRyde
more information >
Continue Researching
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-3/4 - Pre-Greased
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 95" Long - 3,500 lbs
- Shop: Dexter Trailer Axle Beam with Standard Spindles - 89" Long - 3,500 lbs
- Shop: Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-3/4 - Pre-Greased
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 5 on 4-1/2 - Galvanized
- Shop: Trailer Axle Beam with Easy Grease Spindles - 89" Long - 3,500 lbs
- Q&A: Process for Changing a Damaged Spindle on a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Most Popular Wheel Bearings
- Search Results: spindle
- Q&A: Is a Damaged Spindle Safe to Use If Hub Fits It
- Video: Remove, Inspect, and Reinstall Trailer Bearings, Race, and Seals Demonstration
- Shop: U-Bolt Kit for Mounting 3,500-lb, Round Trailer Axles - 5-1/2" Long U-Bolts
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Video: Bearing Repacking and Grease Seals Installation
- Search Results: washer
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Q&A: Should Trailer Axle Be Bowed Down in Middle
- Q&A: What Might Cause Tire Inner Sidewall Rubbing on Trailer Frame
- Q&A: How to Check for a Bent Trailer Axle Spindle
- Video: Dexter Trailer Axle Beam w/ Standard Spindles - 3,500 lbs Installation
- Video: Trailer Hub Inspection Demonstration
- Search Results: grease
- Search Results: l44649
- Shop: Suspension Enhancement
- Search Results: 3500 hub
- Video: Dexter Axle Trailer Axles - Leaf Spring Suspension - T3584F-EZ-8974 Review
- Video: Review 2 of Dexter Axle Trailer Axles - Leaf Spring Suspension - 7359765
- Video: etrailer Trailer Idler Hub Assembly Review and Installation
- Search Results: 3500 lb axle