Replacement Barrel Nut Set for Yakima Skybox 18 Carbonite

Question

Question:

Ive lost one of the barrel nuts to my just-purchased Yakima Skybox 18 Carbonite rooftop box. Will this replacement nut fit that? It wasnt included in the model numbers that were listed, but appears to have the same hardware as the models that were.

asked by: Andy C

0

Expert Reply:

I checked with Yakima and replacement barrel nut set # Y8870083 is indeed a fit for the Skybox 18 Carbonite!

expert reply by: Michael H

0

Answer 1

Thank you for all of the info and pictures! I forwarded them on to my contact at Yakima and it looks like you have the old SkyBox Pro 16 Silver 8007179. Even though this box has been discontinued we do have quite a few replacement parts for it: Cam…

view full answer...

Answer 2

It is possible to use the trailer wiring harness, #118467, to wire a back-up camera to your 2011 Subaru Forester. However, there could be issue in how the camera will operate and to the vehicle's wiring. You will have to find a 12-volt power…

view full answer...

Answer 3

You're looking for the Replacement Barrel Nut for Yakima SkyBox Rooftop Box #Y8870083, which according to my contact at Yakima is 1-1/4" long and has a 1/4"-20 thread pitch.

view full answer...

Answer 4

The length of the Replacement Barrel Nut for the Yakima SkyBox Rooftop Box is 1-1/4 inches and the diameter is 7/16 of an inch. This barrel nut is designed as a replacement part for Yakima SkyBox Mounting Hardware. It fits a 1/4 inch - 20 size bolt.…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 11

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Replacement Barrel Nut Set for Yakima Skybox 18 Carbonite

Product Page this Question was Asked From

Continue Researching