Custom-Fit 2-Inch Trailer Hitch Availability for 2015 Jeep Renegade Latitude

Question

Question:

Ive searched through the Internet, but have not found a hitch which is specific to my vehicle... Does the Curt #13219 class III hitch 2 in fit a Jeep Renegade Latitude model 2015? Thank you for your attention... Oh... And do you have a photo of one installed. Thank you.

asked by: Patrick M

0

Expert Reply:

Both 1-1/4-inch Class II and 2-inch Class III custom-fit hitches are offered for your 2015 Jeep Renegade Latitude. All can be seen on the included link.

Curt Class III hitch # C13269 fits all Renegade models. This hitch includes all hardware and installs without drilling. We have not had a chance to video an install on the 2015 Renegade.

If you plan to tow use ball mount part # C45030 and for a wiring harness you can use # C56274. For a hitch ball use either 2-inch ball # 63845 or 2-5/16-inch ball # 63847. To secure your ball mount use lock # e98880.

expert reply by: Adam R

0

Answer 1

It sounds like your 2015 Jeep Renegade Trailhawk has the 14mm bolts in place instead of the rubber plugs. These are usually found on models that have the factory tow hooks. You will remove the bolts to install the hitch. Since the bolts are on so…

view full answer...

Answer 2

The amount of clearance you have between the ground and mobility scooter carrier will be largely dependent on the carrier you choose, I recommend one with a built-in rise if avavailbe. The height of the trailer hitch isn't adjustable and will…

view full answer...

Answer 3

We actually had the opportunity to install the Draw-Tite Max-Frame Trailer Hitch Receiver #76021 on a 2018 Jeep Renegade Latitude and found from the ground to the top of the receiver tube is 10-1/4". Since this is a 2" receiver we…

view full answer...

Answer 4

The reason you want to run the power wire all the way up to battery is so that you bypass all of the delicate wiring of your vehicle. The power wire is required on trailer wiring harnesses for some vehicles because the electrical system on those…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 11

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 12

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Custom-Fit 2-Inch Trailer Hitch Availability for 2015 Jeep Renegade Latitude

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching