Suspension Enhancement for a 2004 Dodge Ram with Crane Installed in Bed

Question

Question:

I got a 2004 dodge ram 3500 st w drw and I got to upgrade my suspension the most I want to lift is a 2500 pick up I was thinking the 5000+ super springs and timbern ses but Im wondering if thats enough

asked by: William W

0

Expert Reply:

For your 2004 Dodge Ram 3500 the suspension enhancement we offer that provides the most support is the Timbren kit part # TDR3500CA that provides 8,600 lbs of support. You can only use one suspension enhancement setup on a vehicle at a time so this would be your best option.

expert reply by: Jameson C

0

Answer 1

The Timbren Rear Suspension Enhancement System, part #TDR3500CA is a confirmed fit for your 2015 Ram 3500. The system does come with a 1 inch spacer just in case you need additional length. I have attached a drawing that shows the clearance that you…

view full answer...

Answer 2

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 3

Your trailer looks awesome! The Road armor equalizers #LC696740 and Equa-Flex Cushioned Equalizers #LC279687 are both pretty similar in performance even though the Road Armor has two dampers. The main difference is the size of the equalizers. The…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 8

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Answer 9

The clip that you are referring to that holds the 7-way plug to the socket is typically found on the connector which is why the #HM40940 does not come with it. I wish we sold that piece by itself but only way to get it is to go with a new harness…

view full answer...

Answer 10

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 11

Lippert Components purchased the Everchill line so we finally have some manufacturer support for the Everchill RV Refrigerator w/ Freezer Drawer #WAY44FR. I've attached the manual below to help you out.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Suspension Enhancement for a 2004 Dodge Ram with Crane Installed in Bed

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching